owners manual Seat Arona

all ratings: 0 average rating: 5

Driving Inertia mode the need for fuel) facilitates improved fuelIf all the positions of the selector lever are a consumption and emission balance.shown over a light background on the instru-at d The inertia mode enables the kinetic energy ment panel display, there is a system fault al of the vehicle to be harnessed enabling cer-WARNINGand the automatic gearbox will operate in hnic tain stretches to be driven without using the with the backup programme. When the back- ● If the inertia mode has been switched on, ec accelerator. This enables fuel to be saved. T up programme is activated, it is possible to take into account, when approaching an ob- Use the inertia mode to “let the vehicle roll” drive the vehicle, however, at low speeds and stacle and releasing the accelerator pedal, before, for example, arriving in a town. within a selected range of gears. In some ca- that the vehicle will not decelerate in the usu- al manner: risk of accident!ses driving in reverse gear may not be possi-e ic Switching on inertia mode ble. ● When using inertia mode while travelling Adv down hills, the vehicle can increase speed: Important: selector lever must be in position CAUTION risk of accident! D, gradients below 12 %. ● If other users drive your vehicle, warn themIf the gearbox operates with the backup pro- – Select, in SEAT Drive Profile*, Eco mode about inertia mode. gramme, take the vehicle to a specialised ››› page 225. workshop and have the fault repaired without delay. – Take your foot off the accelerator. ation Note The driver message Inertia will be dis-● Inertia mode is only available in eco (SEAT Oper played. At speeds higher than 20 km/h (12 Drive Profile*) driving mode. Clutch mph), the gearbox will automatically disen- ● The driver message Inertia is only dis- gage and the vehicle will roll freely, without s played with the current consumption. In iner-  Clutch overheating! Please ie the effect of the engine brake. While the vehi- tia mode the gear will no longer be displayed stop! cle rolls, the engine runs at idling speed. enc (for example “E” will appear instead of “E7”). g The clutch has overheated and could be dam- ● On downhill sections with gradients above Stopping inertia mode aged. Stop the vehicle and wait for the gear- 15 %, the inertia mode will automatically be Emer box to cool with the engine at idling speed switched off temporarily. – Press the brake or the accelerator pedal. and the selector lever in position P. When the To make use of the braking force and switch warning lamp and the driver message switch off the engine again, simply press the brake off, have the fault corrected by a specialised ety Backup programme pedal briefly. workshop without delay. If the warning lamp Saf and the driver message do not switch off, do A backup programme is in place if a fault Applying both the inertia mode (= prolonged not continue driving. Seek specialist assis- should occur in the control system. section with less energy) and the switching tance. off using inertia (= shorter section without 189

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders