owners manual Opel Vectra

all ratings: 0 average rating: 5

Driving and operation185 Overrun Correct gear selection Cooling fan The fuel supply is automatically shut off Transmission in neutral and without The cooling fan is controlled via a during overrun, e.g. when the vehicle is revving in the lower gears. Stop-and-go thermoswitch and therefore only runs if being driven down long gradients or when traffic and driving at a speed too high for necessary. braking. To enable the overrun cut-off to the selected gear or transmission ratio The cooling fan automatically switches on take effect, do not accelerate during increases wear and fuel consumption. when the diesel particle filter3 is being overrun and, if in manual transmission Change down cleaned depending on the engine. mode, do not depress clutch pedal. To When decreasing speed, shift down into prevent damage to the catalytic converter, the next lowest gear. Do not slip the clutch Pedals overrun cut-off is temporarily deactivated with a high-revving engine. This is Do not place any objects in the footwell when the catalytic converter temperature especially important when hill climbing.which could slip under the pedals and is high. inhibit the pedal travel. Vehicles with turbocharged engine 3Clutch operation To ensure the pedal travel is uninhibited, Flow-generated noises may be audible if Always depress the clutch pedal hard to there must be no mats in the area of the the accelerator is released quickly on the floor to prevent shifting difficulties and pedals. account of airflow in the turbocharger. transmission damage. When driving do not use the pedal as a Battery care Engine speed footrest; this will cause substantial clutch When driving slowly or when the vehicle is Drive in a low engine speed range for each wear. stationary, e.g. in slow urban traffic, stop- gear as much as possible. and-go traffic or traffic jams, turn off all Warming up unnecessary electrical loads where Allow the engine to warm up whilst driving. possible (e.g. heated rear window, heated Do not warm it up by letting it run at idling seats 3). speed. Do not apply full throttle until the Depress clutch pedal when starting in order engine has reached operating to relieve the strain on the starter and the temperature. battery. After a cold start, the automatic transmission 3 or Easytronic 3 in Automatic mode shifts into higher gears at higher rpm. This allows the catalytic converter to quickly reach the temperature required for optimum pollutant reduction.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders