owners manual Seat Ateca

all ratings: 0 average rating: 5

Operation  Gearbox: press the brake andYou should also avoid driving with the engine●Reduction of volatile components, includ- engage a gear again. speed too low. Change down to a lower gearing odour, in plastic materials. when the engine no longer runs “smoothly”. ●Use of CFC-free coolants. If the fault was caused by a gearbox with a If the engine revs too much, cut fuel injection high temperature, this driver message will be to protect the engine. Ban on heavy metals, with the exceptions displayed when the gearbox has cooled dictated by law (Annex II of ELV Directive again. 2000/53/EC): cadmium, lead, mercury, hexa- valent chromium. Environmental compatibility Run-in and economical drivingEnvironmental protection is a top priority inManufacturing methods the design, choice of materials and manufac- ●Reduction of the quantity of thinner in the ture of your new SEAT. Running-in the engine protective wax for cavities. ●Use of plastic film as protection during ve- A new vehicle should be run in over a dis-Constructive measures to encourage recy- hicle transport. anc cling t e of 1500 km (1000 miles). For the first ●Use of solvent-free adhesives. 1,000 km the engine speed should not ex- ●Joints and connections designed for easy ceed 2/3 of the maximum permissible engine ● Use of CFC-free coolants in cooling sys- dismantling speed. In doing so, do not accelerate at full tems. ●Modular construction to facilitate disman- throttle and do not drive with a trailer! From ●Recycling and energy recovery from resi- tling 1000 to 1500 km (600 to 1000 miles) you dues (RDF). ●Increased use of single-grade materials. can gradually increase the engine rpm and ●Improvement in the quality of waste water. road speed. ●Plastic parts and elastomers are marked in ●Use of systems for the recovery of residual accordance with ISO 1043, ISO 11469 and During its first few hours of running, the in- heat (thermal recovery, enthalpy wheels, ISO 1629. ternal friction in the engine is greater than etc.). later on when all the moving parts have bed- Choice of materials ●The use of water-soluble paints. ded down. ●Use of recycled materials. How the vehicle is driven for the first 1,500 km influences the future engine perform-●Use of compatible plastics in the same part ance. Subsequently, also drive at a moderateif its components are not easily separated. rate, especially when the engine is still cold: ●Use of recycled materials and/or materials this will lead to less engine wear and tear originating from renewable sources. and will prolong its useful life. 184

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders