owners manual Seat Toledo

all ratings: 0 average rating: 5

Advice How to jump start: description2. Connect one end of the red jump lead to8. Start the engine of the vehicle with the flat the po itive + s terminal of the vehiclebattery and wait 2 or 3 minutes until the with the flat battery A ››› Fig. 129.engine is “running”. 3. Connect the other end of the red jump Removing the jump leads lead to the positive terminal + in the ve- hicle providing assistance B .9. Before you remove the jump leads, switch off the dipped beam headlights (if they 4. For vehicles without Start-Stop system: are switched on). connect one end of the black jump lead to the negative terminal – of the vehicle10.Turn on the heater blower and heated rear providing the current B ››› Fig. 129.window in the vehicle with the flat battery. This helps minimise voltage peaks which – For vehicles with Start-Stop system: con- are generated when the leads are discon- Fig. 129 Diagram of connections for vehiclesnect one end of the black jump lead X to a nected. without Start Stop systemsuitable ground terminal, to a solid piece of metal in the engine block, or to the engine11.When the engine is running, disconnect block itself ››› Fig. 130.the leads in reverse order to the details given above. 5. Connect the other end of the black jump lead X to a solid metal component bolted Connect the battery clamps so they have to the engine block or to the engine block good metal-to-metal contact with the battery itself of the vehicle with the flat battery. terminals. Do not connect it to a point near the bat- If the engine fails to start, switch off the start- tery A . er after about 10 seconds and try again after 6. Position the leads in such a way that they about 1 minute. cannot come into contact with any moving parts in the engine compartment. Fig. 130 Diagram of connections for vehicles WARNING with Start Stop system ● Please note the safety warnings referring to Starting working in the engine compartment Jump lead terminal connections 7. Start the engine of the vehicle with the››› page 132. 1. Switch off the ignition of both vehiclesboosting battery and let it run at idling ● The battery providing assistance must have ››› . speed. the same voltage as the flat battery (12V) and approximately the same capacity (see imprint 158

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders