owners manual Skoda Citigo

all ratings: 0 average rating: 5

Components of the breakdown kit Preparing to use the breakdown kit First read and observe the introductory information and safety warn- ings on page ĖĘė. ä 0he following preparatory work must be carried out before using the breakdown kit. › In the event of a puncture, park the vehicle as far away as possible from the flow of traffic. Park on as flat and firm a surface as possible. › Let all of the occupants get out. 3hile changing a tyre, the occupants of the vehicle should not stand on the road (instead they should remain behind a crash barrier). › Switch off the engine and move the gearshift lever into Neutral or move the selector lever for the automatic gearbox into position N. › Firmly apply the handbrake. › Check that you can carry out the repairs with the breakdown kit » page ĖĘė, Breakdown kit. Fig. ĖĖĚ Components of the breakdown kit › Remove the breakdown kit from the luggage compartment. › Stick the sticker ė » Fig. ĖĖĚ on page ĖĘĘ on the dash panel in view of the driv- First read and observe the introductory information and safety warn- er. äings on page ĖĘė. › Do not remove the foreign body, e.g. screw or nail, from the tyre. 0he breakdown kit contains the following parts: › 1nscrew the valve cap. › 1se the valve remover Ė to unscrew the valve core and place it on a clean sur- Ė 2alve remover Ð face (rag, paper, etc.). ė Sticker with speed designation “max. ĝĕ km/h”/“max. Ěĕ mph” Ę Inflation hose with plug Sealing and inflating tyres ę Air compressor Ě 0yre inflation hose First read and observe the introductory information and safety warn- ě 0yre inflation pressure indicator ings on page ĖĘė. ä Ĝ Air release valve Sealing ĝ ON and OFF switch Forcefully shake the tyre inflator bottle Ėĕ » Fig. ĖĖĚ on page ĖĘĘ several times. › Ğ Ėė volt cable connector Firmly screw the inflation hose Ę onto the tyre inflator bottle Ėĕ clockwise. › Ėĕ 0yre inflator bottle with sealing agent 0he film on the cap is pierced automatically. ĖĖ Replacement valve core › Remove the plug from the inflation hose Ę and plug the open end fully onto the tyre valve. 0he valve remover Ė has a slot at its lower end which fits into the valve core. Hold the bottle Ėĕ with the bottom facing upwards and fill all of the sealing 0his is the only way in which you can remove and re-install the valve core from› Ð agent from the tyre inflator bottle into the tyre. the tyre valve. 0he same also applies to the replacement valve core ĖĖ . › Remove the empty tyre inflator bottle from the valve. Screw the valve core back into the tyre valve using the valve remover Ė .£ › Do-it-yourselfĖĘĘ

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders