or
owners manual Alfa Romeo 33
owners manual Alfa Romeo 33 - year of production: 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993, 1994, 1995 - Alfa Romeo 33 owners manual EN
Document: pdf (12.9 MB) 378 pages
all ratings: 0 average rating: 5
text version of content this owner's manual page from owners manual to the vehicle Alfa Romeo 33, year of production 1983 - 1995:
ENGINE COOLINGSYSTEM
LEAK TEST compressed air through radiator
6. Test again radiator for leakages
breather pipe until a pressure of
as described above and then refinish
98.1 + 107.9kPa; (0.9+ 1.0 bar;
I. Remove radiator from car (Refer radiator with black synthetic enamel.
1 + 1 .I kg/cm2 ; 14.22+ 15.64 psi) is
In case of leakages from radiator
to: Radiator Removal and Installa-
tion). reached. fitted with side tanks (with gaskets),
4. If leakages are found, clean area
replace the radiator.
2. Close radiator outlet and inlet
to be soldered by a wire brush and
unions. 7. Refit radiator to car (Refer to:
deoxidate by “baked” hydrochloricRadiator - Removal and Installation).
3. lmmerge radiator in a tank
acid (zinc chloride). Fill with coolant and check for
previously filled with water and
5. Solder the leaking area., leakages.
check for possible leakages inflating
ELECTRIC FAN CONTROL THERMAL CONTACT
CHECKS AND
REMO-VAL AND
INSPECTIONS
INSTALLATION
Check thermal contact according to
1. Drain coolant.
the following procedure:
2. Disconnect thermal contact ca-
bles. 1. Fit thermal contact@ to the
3. Unscrew thermal contact fromtest equipment used for thermostat
radiator. test.
2. Fill container with coolant and
4. Installation is carried out in
reverse order of removal. switch on equipment to heat water.
5. At the end of installation3. When warning light0 illumi-
fill the circuit with
procedure, nates, verify that temperature shown
on thermometer dial indicator corre-
coolant and let the engine rotates
sponds to the thermal contact setting
until coolant reaches the temperature
of 88+ 92°C (190.4+ 197.6”F) and value 88+ 92°C (190.4+ 197.6”F).
verify that electric fan inserts.
1 Warning light 2 Thermal contact
HEADER TANKPRESSURIZED PLUG
LEAK TEST
1. Screw fitting@ to test equip-
ment and insert on header tank
pressurited plug.
2. Act on tool to increase pressure
and check on dial indicator that
blowoff valve opens at the required
setting pressure.
Pressurited plug setting pressure
69.6 kPa; (0.69 bar;
0.7 kg/cm’ ; 9.95 psi) 1 Pipe fitting 2 Pressurized plug
May 1983 07-6
Download PDFClick here to download a pdf file with an instruction manual for Alfa Romeo 33
year of production from: 1983
Do you prefer pdf format?Find out how to download
Enter the code to download PDF file:
:
All pages in one PDF file!
How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.
How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.
:
Alfa Romeo 33 owners manual
pages 123 - 129
pages 123 - 129
Alfa Romeo 33 owners manual
page 126 / 378
this site is maintained by advertising - for view instructions, turn off ad blocking in your browser
Download PDFOthers owner's manuals for this model: