Nissan 370Z owners manual page 117

text version of content this owner's manual page from owners manual to the vehicle Nissan 370Z, year of production 2009:

Black plate (115,1) . push and hold both the HomeLink® and 2. When the indicator light begins to flash FCC Notice: hand-held transmitter buttons without inter- slowly (after 20 seconds), position the For USA: ruption. hand-held transmitter 2 to 5 in (50 to 127 This device complies with Part 15 of the . position the hand-held transmitter 2 to 5 in mm) away from the HomeLink® surface. (50 to 127 mm) away from the HomeLink® FCC Rules. Operation is subject to the 3. Push and hold the hand-held transmitter following two conditions: surface. Hold the transmitter in that position button. for up to 15 seconds. If HomeLink® is not ® (1) This device may not cause harmful programmed within that time, try holding the 4. The HomeLink indicator light will flash, firstinterference, and (2) this device must transmitter in another position - keeping the slowly and then rapidly. When the indicator accept any interference received, including indicator light in view at all times. light begins to flash rapidly, release both interference that may cause undesired buttons. operation. If you continue to have programming difficulties, The HomeLink® Universal Transceiver button please contact the NISSAN Consumer Affairs Note: Changes or modifications not ex- Department. The phone numbers are located in has now been reprogrammed. The new device pressly approved by the party responsible can be activated by pushing the HomeLink® the Foreword of this Owner’s Manual. for compliance could void the user’s button that was just programmed. This proce- authority to operate the equipment. CLEARINGTHE PROGRAMMED IN- dure will not affect any other programmed FORMATION HomeLink® buttons. For Canada: GUID-D24322DD-9D17-4521-9A9A-F91495CB6460 This device complies with RSS-210 of Individual buttons cannot be cleared, however to IF YOUR VEHICLE IS STOLEN clear all programming, push and hold the two GUID-0F761B9B-C5CA-46F7-A59B-2BD8DCA0EB26Industry Canada. Operation is subject to outside buttons and release when the indicator If your vehicle is stolen, you should change the the following two conditions: codes of any non-rolling code device that has light begins to flash (in approximately 20 ® (1) this device may not cause interference, seconds). been programmed into HomeLink . Consult the and (2) this device must accept any inter- Owner’s Manual of each device or call the ference, including interference that may REPROGRAMMINGASINGLE manufacturer or dealer of those devices for HomeLink® BUTTON additional information. cause undesired operation of the device. GUID-A92FC9F7-27BF-493C-A32E-A97B1F853523 To reprogram a HomeLink® Universal Transcei- When your vehicle is recovered, you will ver button, complete the following. need to reprogram the HomeLink® Univer- ® sal Transceiver with your new transmitter 1. Push and hold the desired HomeLink button. Do not release the button until step information. 4 has been completed. Instruments and controls 2-53 [ Edit: 2012/ 4/ 11Model: Z34-D ]

owners manual Nissan 370Z

owners manual Nissan 370Z - year of production: 2009 - Nissan 370Z owners manual EN