Nissan 370Z owners manual page 116

text version of content this owner's manual page from owners manual to the vehicle Nissan 370Z, year of production 2009:

Black plate (114,1) ® ® button - releasing when the device begins to HomeLink button you have just pro- under “Programming HomeLink ”) while you activate. grammed. Push and release the HomeLink® push and re-push (“cycle”) your hand-held 5. Ifthe indicator light on HomeLink® blinks button up to three times to complete the transmitter every 2 seconds until the indicator rapidly for two seconds and then turns solid, training. light flashes rapidly (indicating successful pro- HomeLink® ® gramming). has picked up a “rolling code” 8. Your HomeLink button should now be garage door opener signal. You will need to programmed. To program the remaining NOTE: proceed with the next steps to train HomeLink® buttons for additional door or ® If programmingagaragedooropener,etc., HomeLink , completing the programming gate openers, follow steps 2 through 8 only. it is advised to unplug the device during may require a ladder and another person 9. If you have any questions or are having the “cycling” process to prevent possible for convenience. difficulty programming your HomeLink® but- damage to the garage door opener com- 6. Push and release the program button tons, refer to the HomeLink® web site at: ponents. located on the garage door opener’s motor www.homelink.com or call 1-800-355- ® OPERATINGTHE HomeLink UNIVER- to activate the “training mode”. This button is 3515. SALTRANSCEIVER usually located near the antenna wire that NOTE: GUID-6AA5C6CB-11CB-483C-9527-1FFDF58B7634 ® hangs down from the motor. If the wire HomeLink Universal Transceiver (once pro- originates from under a light lens, you will Do not repeat step 1 unless you want to grammed) may now be used to activate the “clear” all previously programmed need to remove the lens to access the garage door, etc. To operate, simply push the HomeLink® buttons. appropriate programmed HomeLink® Universal training button. Transceiver button. The red indicator light will NOTE: If you have any questions or are having difficulty programming your HomeLink® buttons, please illuminate while the signal is being transmitted. Once you have pushed and released ® the training button on the garage door refer to the HomeLink web site at: www. PROGRAMMINGTROUBLE-DIAGNO- opener’s motor and the “training light” homelink.com or call 1-800-355-3515. SIS ® GUID-174F1BA4-F106-43E5-A4BA-2E2C80EDFDEB is lit, you have 30 seconds in which to PROGRAMMINGHomeLink FOR CA- If HomeLink® does not quickly learn the hand- perform step 7. For convenience, use NADIAN CUSTOMERS held transmitter information: GUID-21498FF2-60BD-4737-AC1C-3A2C33FC4A9A the help of a second person to assist Prior to 1992, D.O.C. regulations required. replace the hand-held transmitter batteries when performing this step. hand-held transmitters to stop transmitting after with new batteries. 7. Quickly (within 30 seconds of pushing and 2 seconds. To program your hand-held trans- . position the hand-held transmitter with its mitter to HomeLink® releasing the garage door opener training , continue to push and hold battery area facing away from the button) and firmly push and release the the HomeLink® button (note steps 2 through 4 HomeLink® surface. 2-52 Instruments and controls [ Edit: 2012/ 4/ 11Model: Z34-D ]

owners manual Nissan 370Z

owners manual Nissan 370Z - year of production: 2009 - Nissan 370Z owners manual EN