owners manual Seat Toledo

all ratings: 0 average rating: 5

Operation Starting the engine Brakes and brake servo ● Insufficient fuel can cause the engine to run ● irregularly or to switch off. Brake assist sys- Move the gearbox lever into neutral or systems tems could be impaired. Risk of accident! move the selector lever to position P or N and pull firmly on the handbrake. ● Always adjust your driving style to suit visi- Introduction bility, the weather and road and traffic condi- ●Press the clutch pedal all the way down 2 tions. The best vehicle safety offered by ››› Fig. 89 ››› page 97 and start the engine 3 , WARNING brake assist systems must never encourage without pressing the accelerator. Keep the you to run greater risks. Risk of accident! ● The brake servo only works when the en- clutch pedal pressed down until the engine gine is running. Braking when the engine is starts. switched off requires applying more strength CAUTION ●Release the ignition key as soon as the en- to the brake pedal. Risk of accident! ● Observe the information concerning new gine starts. The key returns to position 2 . ● Press down on the clutch pedal when stop- brake pads ››› page 104 . ●If the engine does not start after 10 sec- ping and braking with a manual gearbox, pet- ● Where braking is not necessary, do not onds, turn the key back to position 1 . Re-rol engine vehicle at low speed. Otherwise, wear down the brake pads by pressing down peat the action after 30 seconds.the brake servo might not work properly. Risk gently on the brake pedal. This causes the of accident! ●Release the handbrake before moving off. brakes to overheat, increasing their wear and ● In the event of damage to the standard increasing braking distances. front spoiler or where a different front spoil- ● To ensure the brake assist systems work er, wheel trims, etc. are subsequently fitted, Switching off the engine properly, all wheels must be fitted with tyres make sure the air vent to the brakes on the approved by the manufacturer. front wheels is not blocked. Otherwise, brak- Stop the engine by turning the ignition key to ing operations may be impaired. Risk of acci- position 1 ››› Fig. 89 ››› page 97. dent! Note ● Always fully release the handbrake. If it is ● If you brake suddenly and the brake system only partially released, this will cause over- control unit regards the situation as hazard- heating of the rear brakes, which can impair ous for the drivers behind you, the brake the function of the brake system. Risk of acci- lights will begin to flash automatically. After dent! reducing speed to approximately 10 km/h (6 ● Never leave children unsupervised in themph) or stopping the vehicle, the brake lights vehicle. They could release the handbrake orwill stop flashing and the hazard warning move the gear lever. The vehicle could startlights will switch on. The hazard warning moving. Risk of accident! lights are automatically switched off when you accelerate or restart the vehicle. 98

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders