Mitsubishi Outlander PHEV III 3 owners manual page 99

text version of content this owner's manual page from owners manual to the vehicle Mitsubishi Outlander PHEV, year of production 2012:

B０0203201E３.book 20 ページ㸰㸮㸯㸱年㸯㸯月㸯９日　火曜日　午前㸯㸯時５㸮分 Child restraint WARNING Installing a child restraint sys- 2.Route the belt through the child restraint zBefore putting the child in the restraint, tem to a 3-point type seat belt according to the child restraint system be sure to make the conversion of the manufacturer’s instructions, then insert retractor from the ELR mode to the ALR (with emergency locking mech- the latch plate into the buckle. mode. By doing so, the child restraint sys- anism) 3.Remove all slack by using the locking tem is always tightly secured to the seat by E00407101712 clip. the automatic lock. By converting to ALR For safety, you are advised to install the child 4.Attach the top tether anchor strap to the 5 mode, the movement of the child restraint restraint system using a 3-point type seat belt child restraint anchorage point and tighten system in the event of sudden braking or with emergency/automatic locking mecha- the tether anchor strap (refer to page an accident will be reduced, decreasingnism. If you cannot avoid installing it using 5-16). the risk of seriously injuring the child or another type of seat belt, follow the instruc- 5.Before putting the child in the restraint, other occupants. tions given below. push and pull the restraint in all directions to be sure it is secure. Do this before each NOTE use. zIf a person wearing the seat belt moves their To remove upper body significantly such that the belt completely unwinds, the retractor may switch to its ALR mode and lock, thus pre- Remove the plate from the buckle, then venting further movement. If this happens, remove the seat belt from the child restraint the person should switch the retractor back system. to its ELR mode by taking off the seat belt and fully rewinding it. The person should WARNING then wear the seat belt again. zFor some types of child restraint, the lock- ing clip (A) should be used to help avoid To remove personal injury during a collision or sud- To install den manoeuvre. 1.Remove the plate from the buckle, then It must be fitted and used in accordance remove the seat belt from the child 1.Place the child restraint system on the rear with the child restraint manufacturer’s restraint system. seat. instructions. 2.Fully rewind the seat belt to deactivate the The locking clip must be removed when ALR mode. the child restraint is removed. 5-20 Seat and seat belts

owners manual Mitsubishi Outlander PHEV

owners manual Mitsubishi Outlander PHEV - year of production: 2012 - Mitsubishi Outlander PHEV III 3 owners manual EN