manual Audi R8 I 1 owners manual page 98

text version of content this owner's manual page from owners manual to the vehicle Audi R8, year of production 2006 - 2015:

document_0900452a816e6cc9.book Seite 96 Mittwoch, 21. Februar 2007 1:32 13 96 HomeLink 7. Press the activator button on the original hand-held transmitter. 8. As you do so, watch the turn signals on your vehicle. HomeLink confirms successful programming by flashing all four turn signals three times. 9. If the turn signals fail to flash three times, repeat the procedure with the transmitter held at a different Fig. 81 Front bumperdistance from the bumper. At the operating unit The proper distance between the hand-held transmitter and the HomeLink module inside the front bumper depends on the system 1. Switch on the ignition (do not start the engine). you want to train. It may require several attempts. 2. Press and hold down the two outer buttons of the The turn signals will flash once if the time limit for the programming HomeLink® operating unit ⇒ page 95, fig. 80 until the mode has been exceeded. In this case the programming procedure A needs to be performed again. Repeat the sequence on the operating indicator diode ⇒page95, fig. 80 begins to flash after A unit starting with step 3. about 20 seconds. This means that all previously stored data has been deleted. The programming instructions above also apply to the other control 3. Press the particular HomeLink button which you would buttons. Start with step 3 on the operating unit if you wish to like to program. proceed and program the other two buttons. If the garage door or other devices st ill fail to be activated with the 4. Wait until the diode A⇒page95, fig. 80 begins to flash. HomeLink control buttons after programming is completed, it is A The HomeLink module now remains in training mode for possible that these systems might be working with a rolling code 5 minutes. instead of the normal fixed security code. If this is the case, a rolling code programming is required in addition to the steps described 5. Now step in front of your vehicle with the original hand-above ⇒page97. held transmitter for the garage door opener or any other device you wish to assign to the HomeLink control button ⇒fig. 81. At the front bumper 6. Hold the original hand-held transmitter for the device you wish to program close to the front bumper, directly above the radiator grille ⇒ fig. 81.

owners manual Audi R8

owners manual Audi R8 - year of production: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015 - Audi R8 I 1 owners manual EN