Nissan Skyline R34 workshop service manual page 95

text version of content this owner's manual page from owners manual to the vehicle Nissan Skyline, year of production 1998 - 2002:

ANTI-LOCK BRAKE SYSTEM Self-diagnosis (Cont'd) MALFUNCTION CODEISYMPTOM CHART Malfunction Malfunctioning part ABS warning Fail-safe code No. lamp ON operation 18 1 Different number of teeth of sensor rotors 1010 2 1 Front right wheel sensor (open-circuit) 0 0 - -- 22 Front right wheel sensor (short-circuit)'4 0 0 25 Front left wheel sensor (open-circuit) 0 0 26 I Front left wheel sensor (short-circuiQ.4 1010 3 1 I Rear wheel sensor (open-circuit) 1010 32 Rear wheel sensor (short-circuit)'4 1 0 1 0 41 I Front right outlet ABS solenoid valve and circuit 1010 - - 42 Front right inlet ABS solenoid valve and circuit 0 0 45 Front left outlet ABS solenoid valve and circuit 0 0 -- - - 46 Front left inlet ABS solenoid valve and circuit 0 1 0 55 1 Rear outlet ABS solenoid valve and circuit 1010 56 1 Rear inlet ABS solenoid valve and circuit 1010 57 1 Power supply (Low or high voltage)*2 I 0 I -'I 61 ABS actuator motor or motor relayg3 0 0 63 ABS actuator relay 0 0 I At self-diagno- ( ABS control unit or data link connector for CONSULT is poorly 1 I No indication sis only connected. Ignition switch ABS control unit1Fuse is blown or ABS warning lamp has an ON open circuit. At self-diagno- I sis only I ABS control unit I I ABS control unit1ABS actuator relay is stuck to OFFJABS I Stays ON lgnition switch power supply circuit, ABS actuator relay drive side power sup- ply (coil side) circuit, and ABS warning lamp circuit are short- circuited./ABS control unit connector is disconnected or poorly I I connected. I I - -- '1: Fail-safe operation does not activate. A signal from ABS control unit suspends ABS control operation. Brakes operate con- ventionally. After specified power supply voltage resumes, ABS warning lamp goes out, allowing for ABS control operation. '2: The code No. does not indicate a malfunction related to the ABS control unit. Do not replace the ABS control unit even if the code No. appears. '3: The code No. can sometimes appear when the ABS motor ground circuit is loose or disconnected. When it appears, always check the ground circuit for improper installation. '4: ABS warning lamp turns on if a wheel or wheels spin for 10 to 80 seconds (depending on the wheel speed) with the vehicle stuck in snow, ice, or mud. This is a normal condition. After repairing short-circuited sensor, turning ignition switch ON lights up ABS warning lamp. Check that ABS warning lamp turns off when the vehicle is driven at approx. 30 krnlh for approx. 1 minute as shown in the self-diagnosis procedure.

owners manual Nissan Skyline

owners manual Nissan Skyline - year of production: 1998, 1999, 2000, 2001, 2002 - Nissan Skyline R34 workshop service manual EN