owners manual Nissan Murano

all ratings: 0 average rating: 5

light flashes rapidly (indicating successful pro-
press and hold both the HomeLinkandREPROGRAMMINGASINGLE gramming). hand-held transmitter buttons without inter-HomeLink BUTTON NOTE: ruption.
position the hand-held transmitter 2 to 5To reprogram a HomeLinkUniversal Trans- If programmingagaragedooropener,etc.,inches (50 to 127 mm) away from theceiver button, complete the following. it is advised to unplug the device duringHomeLink surface. Hold the transmitter in1. Press and hold the desired HomeLink but- the “cycling” process to prevent possiblethat position for up to 15 seconds. Ifton. Do not release the button until step 4 damagetothegaragedooropenercompo-HomeLinkis not programmed within thathas been completed. nents. time, try holding the transmitter in another OPERATING THE HomeLink position - keeping the indicator light in view at2. When the indicator light begins to flash UNIVERSAL TRANSCEIVER all times. slowly (after 20 seconds), position the hand- If you continue to have programming difficulties,held transmitter 2 to 5 inches (50 to 127 mm) The HomeLinkUniversal Transceiver (onceplease contact the NISSAN Consumer Affairsaway from the HomeLink surface. programmed) may now be used to activate theDepartment. The phone numbers are located in3. Press and hold the hand-held transmitter garage door, etc. To operate, simply press thethe Foreword of this Owner’s Manual.button. appropriate programmed HomeLinkUniversalCLEARING THE PROGRAMMED4. The HomeLink indicator light will flash, first Transceiver button. The red indicator light willINFORMATION slowly and then rapidly. When the indicator illuminate while the signal is being transmitted. light begins to flash rapidly, release both PROGRAMMINGTROUBLE Individual buttons cannot be cleared, however tobuttons. DIAGNOSIS clear all programming, press and hold the twoThe HomeLinkUniversal Transceiver button outside buttons and release when the indicatorhas now been reprogrammed. The new device Ifthe HomeLinkdoes not quickly learn thelight begins to flash (approximately 20 seconds).can be activated by pushing the HomeLink hand-held transmitter information: button that was just programmed. This proce-
replace the hand-held transmitter batteries dure will not affect any other programmed with new batteries. HomeLink buttons.
position the hand-held transmitter with its IF YOUR VEHICLE IS STOLEN battery area facing away from the HomeLink If your vehicle is stolen, you should change the surface. codes of any non-rolling code device that has 2-42 Instruments and controls
03.1.28/Z50-D/V5.0 

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders