Nissan Cube owners manual page 90

text version of content this owner's manual page from owners manual to the vehicle Nissan Cube, year of production 2008:

Black plate (90,1) —Anemission control system and/or CVTCAUTION “SECURITY SYSTEMS” later in this section. malfunction has been detected. Check the fuel-filler cap. If the fuel-filler cap is loose orSlip indicator light missing, tighten or install the cap andContinued vehicle operation without continue to drive the vehicle. Thelighthaving the emission control systemThe light will blink when the Vehicle Dynamic should turn off after a few driving trips. If theand/or CVT system checked and re-Control (VDC) system is operating, thus alerting light does not turn off after a fewpaired as necessary could lead to poorthe driver that the vehicle is nearing its traction driving trips, have the vehicle inspected by adriveability, reduced fuel economy, andlimits. The road surface may be slippery. NISSAN dealer. You do not need to havepossible damage to the emission con- your vehicle towed to the dealer.trol system. Low beam indicator light . Malfunction indicator light blinking — An engine misfire has been detected which mayOverdrive off indicator light (if soThelight illuminates when the headlight switch is damage the emission control system. turned to theposition. equipped) To reduce or avoid emission control system Turn signal/hazard indicator lights damage: The overdrive off indicator light illuminates when a) Do not drive at speeds above 45 MPHthe overdrive off mode is selected.The light flashes when the turn signal switch (72 km/h). For additional information, see ““CONTINU-lever or hazard switch is turned on. b) Avoid hard acceleration or deceleration.OUSLY VARIABLE TRANSMISSION (CVT)” in the “5. Starting and driving” section of thisVehicle Dynamic Control (VDC) off c) Avoid steep uphill grades.manual. indicator light d) If possible, reduce the amount of cargoSecurity indicator lightThe light illuminates when the Vehicle Dynamic being hauled or towed. Control (VDC) off switch is pushed to OFF. This The malfunction indicator light may stopThe light blinks when the ignition switch is in theindicates that the VDC system is not operating. blinking and remain illuminated.ACC, OFF or LOCK position. This functionWhen the VDC off indicator light and slip indicates the security system equipped on theindicator light illuminate with the VDC system Have the vehicle inspected by a NISSANvehicle is operational.turned on, this light alerts the driver to the fact dealer. You do not need to have your vehicle that the VDC system’s fail-safe mode is operat- towed to the dealer. If the security system is malfunctioning, this lighting, for example the VDC system may not be will remain on while the ignition switch is in thefunctioning properly. Have the system checked ON position. For additional information, see 2-16 Instruments and controls Model "Z12-D" EDITED: 2009/ 9/ 17

owners manual Nissan Cube

owners manual Nissan Cube - year of production: 2008 - Nissan Cube owners manual EN