owners manual Hyundai Atos

owners manual Hyundai Atos - year of production: 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008 - Hyundai Atos owners manual EN

Document: pdf (1.62 MB) 127 pages

all ratings: 0 average rating: 5

text version of content this owner's manual page from owners manual to the vehicle Hyundai Atos, year of production 1997 - 2008:

WHAT TO DO IN AN EMERGENCY D060F02E-AAT D060G01A-AAT The wheel nuts should be loosened slightly before raising the car. To loosen the nuts, turn5. Raising the Car 6. Changing Wheels the wrench handle counterclockwise. When doing this, be sure that the socket is seated completely over the nut so it cannot slip off. For maximum leverage position the wrench so the handle is to the right as shown in the drawing. Wrench bar Then, while holding the wrench near the end of the handle, pull up on it with steady pressure. Do not remove the nuts at this time. Just loosen them about one-half turn. Wheel nut Wrench D060E01A-AAT AS30120A 4. Put the Jack in Place HFC4022 After inserting a wrench bar into the wheel nut Use the wrench to loosen the wheel nuts, then wrench, install the wrench bar into the jack as remove them with your fingers. Remove the shown in the drawing. To raise the vehicle, turn wheel cover (if installed) from the wheel and slide the wheel off the studs and lay it flat so it the wheel nut wrench clockwise. As the jack begins to raise the vehicle, double check that itcannot roll away. To put the wheel on the hub, pick up the spare tire, line up the holes with the is properly positioned and will not slip. If the jack is on soft ground or sand, you may find it studs and slide the wheel onto them. If this is necessary to place a board, brick, flat stone or difficult, tip the wheel slightly and get the top other object under the base of the jack to keep hole in the wheel lined up with the top stud. it from sinking. Then jiggle the wheel back and forth until the wheel can be slid over the other studs. Raise the car high enough so that the fully D060E01A D060E01V inflated spare tire can be installed. To do this, you will need more ground clearance than is The base of the jack should be placed on firm, required to remove the flat tire. level ground. The jack should be positioned as shown in the drawing. WARNING: Do not get under the car when it is sup- ported by the jack. This is very dangerous as the vehicle could fall and cause serious injury or death. No one should stay in the car while the jack is being used. 3-5

Download PDF

Click here to download a pdf file with an instruction manual for Hyundai Atos
year of production from: 1997

Do you prefer pdf format?
Find out how to download

Enter the code to download PDF file:

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.