owners manual Seat Alhambra

all ratings: 0 average rating: 5

Lights and visibility Adhesive strips for headlights orHeadlight range control, instruments Leaving home: necessary operations adjusting headlights and switch lighting ation – Automatically, at the end of the delay ific period. In those countries where vehicles drive on pec To switch sys-– When the vehicle is locked. s the other side of the road to the home coun- tem off:– When the light switch is turned to po- al try, the asymmetric dipped beam may dazzle sition . hnic – When the ignition is switched on.drivers of oncoming vehicles. Therefore, ec T when driving abroad, adhesive strips should be attached to the headlights or the head- Lighting around the exterior mirrors lights should be adjusted accordingly. The lighting around the exterior mirrors illu- The direction of the headlights can be adjus- e minates the door area on entering and leav- ic ted from the instrument panel, in the Tourist ing the vehicles. It comes on when the vehi- light submenu of the Configuration menu Adv cle is unlocked, when the vehicle door is ››› page 51. Fig. 62 Next to the steering wheel: instru- opened and when the “Coming home” or ment and switch lighting control 1 and “Leaving home” function is switched on. If For those vehicles in which it is not possible headlight range control 2 the equipment includes the light sensor, the to adjust the headlights from the menu, ad- lighting around the exterior mirrors only hesive strips are used to cover certain parts 1 Instrument and switch lighting comes when it is dark. of the headlamp cover or the headlights may When the headlights are switched on, the be adjusted at a specialised workshop. For brightness of the instruments and switchation Note further information, please refer to a special- lighting can be regulated by turning the ● ised workshop. SEAT recommends visiting a The time taken for the headlights to go off Oper switch ››› Fig. 62 1 . can be changed in the Lights & Visibility menutechnical service. and the function can be switched on or off 2 Headlight range control ››› page 47. Note ● The headlight range control ››› Fig. 62 2 is When the “Coming home” function is on, if Use of the Tourist light option and the adhe- the vehicle door is opened there is no audible modified according to the value of the head- sives on the headlights is only allowed if they warning signal to advise that the light is still light beam and the vehicle load status. This are to be used for a short period of time. To ety on. offers the driver optimum visibility and the modify the direction of the headlights perma- headlights do not dazzle oncoming driversSaf nently, please take the vehicle to a special- ised workshop. SEAT recommends visiting a››› . technical service centre. The headlights can only be adjusted when the dipped beam is switched on.» 79

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders