owners manual Skoda Yeti

all ratings: 0 average rating: 5

s2ug.6.book Page 54 Friday, April 9, 2010 2:24 PM 54 Lights and Visibility Deactivating the function daylight driving lights Switching on automatic driving lamp control* – Pull the turn signal light lever towards the steering wheel up to 3 seconds after – Turn the light switch fig. 38 into position . switching on the ignition and at the same time, slide it to the bottom and hold it in this position for at least 3 seconds. Switching off automatic driving lamp control* Activating the function daylight driving lights – Turn the light switch to the position 0,  or . – Pull the turn signal light lever towards the steering wheel up to 3 seconds after If the light switch is in the position , the symbol illuminates when the ignition is switching on the ignition and at the same time, slide it to the top and hold it in this switched on  next to the light switch. If the low beam is activated with the light position for at least 3 seconds. sensor, the symbol  illuminates additionally next to the light switch. In some countries, the national legal provisions require that the rear parking lights If the light comes on automatically, the side lights and low beam as well as licence plate come on together with the bulbs for daylight driving lights when activating the function light light up at the same time. daylight driving lights. If the automatic light control is switched on, the light is regulated with the light sensor On vehicles which are fitted with bulbs for daylight driving lights in the fog lights, the in the rear mirror holder. If the light intensity drops below the set value, e.g when parking lights do not come on when activating the function daylight driving lights.driving during the day into a tunnel, the low beam and the side lights as well as the licence plate light come on automatically. If the light intensity increases again, the When the daylight driving lights are switched on, the lighting of the instrument cluster lights switch off automatically. is switched on as well. Motorway lights On vehicles fitted with an information display*, you can also activate or deactivate in If the automatic light control has been switched on and the vehicle speed is over 140 the menu the function daylight driving lights: km/h for at least 10 seconds, the side lights and low beam are switched on automati-  Setup cally.  Lights & Vision (Lights & Vision) If the vehicle speed is below 65 km/h for at least 2 minutes, the lights are switched off. Automatic driving lamp control* Rain lights If you switch on the windscreen wipe in the operation rain sensor* for longer than 10 seconds or in the operation permanent wipe (position 2 or 3)  page 63 switching on for longer than 15 seconds, the side lights and low beam are switched on automati- cally. The light switches off if the windscreen wipe is in operation rain sensor* for more than 4 minutes or is not switched on in the operation permanent wipe. WARNING The automatic light control only operates as a support. The driver is not Fig. 38 Dash panel: Light switch released from his responsibility to inspect the light and if necessary to switch on the light depending on the light conditions. The light sensor cannot detect for

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders