Subaru XV Crosstrek owners manual page 423

text version of content this owner's manual page from owners manual to the vehicle Subaru XV, year of production 2011:

7-20 Starting and operating/Remote engine start system (dealer option) ing to the following procedure.after 2 minutes. . There is a danger of explosion if 1. Open the driver’s door (the driver’s an incorrect replacement battery door must remain opened throughout the&Systemmaintenanceis used. Replace only with the entire process). NOTE same or equivalent type of bat- 2. Depress and hold the brake pedal. tery. 3. Turn the ignition switch to “ON” thenFor models without “keyless access. Batteries should not be exposed “LOCK” (off), back to “ON” then “LOCK”with push-button start system”:to excessive heat such as sun- (off), back to “ON” then “LOCK” (off), thenIn the event that the vehicle’s battery isshine, fire or the like. back to “ON” again and leave the ignitionreplaced, discharged or disconnected, “ON” throughout the programming pro-it will be necessary to start the vehicleFor models with “keyless access with cess. a minimum of one time using the keypush-button start system”: 4. The system will flash the side markerprior to activating the remote enginePerform the procedure described in “Re- lights, tail lights and parking lights andstart system. This is required to allowplacing battery of access key” F11-45. honk the horn three times, indicating thatthe vehicle electronic systems to re- the system has entered the transmittersynchronize. For models without “keyless access learn mode. ! Changing the batteries with push-button start system”: 5. Press and release the “ ” button on The two 3-volt lithium batteries (model the transmitter that you want to program.CAUTION CR-2032) supplied in your remote engine 6. The system will flash the side marker start transmitter should last approximately lights, tail lights and parking lights and. Donotletdust,oilorwatergetonone year, depending on usage. When the honk the horn one time, indicating that theor in the remote engine startbatteries begin to weaken, you will notice system has learned the transmitter. Upontransmitter when replacing thea decrease in range (distance from the successful programming, the remote startbattery. vehicle that your remote control operates). confirmation transmitter button will flash. Be careful not to damage theFollow the instructions below to change one time. printed circuit board in the re-the remote engine start transmitter bat- mote engine start transmitter teries. 7. Repeat step 5 for any additional transmitters (the system will accept up towhen replacing the battery. eight transmitters). . Becarefulnottoallowchildrento 8. The system will exit the transmittertouch the battery and any re- learn mode if the key is turned to themoved parts; children could “LOCK”(off) position, the door is closed orswallow them.

owners manual Subaru XV

owners manual Subaru XV - year of production: 2011 - Subaru XV Crosstrek owners manual EN