owners manual Ford Edge

all ratings: 0 average rating: 5

Seatbelts Deactivating and Activating the 4. While the safety belt warning light is Belt-Minder Feature on, buckle and then unbuckle the WARNING safety belt. After Step 4, the safety belt warning light flashes for confirmation. While the system allows you to • This will switch the feature off for that switch this feature off, the intent of seating position if it is currently on. the system is to remind you to wear • This will switch the feature on for that your safety belt to improve your chance to seating position if it is currently off. survive an accident. We recommend you leave the system switched on for yourself and others who may use the vehicle. CHILD RESTRAINT AND Note:The driver and front passenger SEATBELT MAINTENANCE warnings switch on and off independently. Inspect the vehicle safety belts and child When you perform this procedure for one safety seat systems periodically to make seating position, do not buckle the other sure they work properly and are not position as this will terminate the process. damaged. Inspect the vehicle and child Read Steps 1–4 thoroughly before seat safety belts to make sure there are no proceeding with the programming nicks, tears or cuts. Replace if necessary. procedure. All vehicle safety belt assemblies, including Before following the procedure, make sure retractors, buckles, front safety belt buckle that: assemblies, buckle support assemblies (slide bar-if equipped), shoulder belt • The parking brake is set. height adjusters (if equipped), shoulder • The transmission is in park (P) or belt guide on seat back (if equipped), child neutral (N). safety seat LATCH and tether anchors, and • The ignition is off. attaching hardware, should be inspected after a crash. Read the child restraint • The driver and front passenger safety manufacturer's instructions for additional belts are unbuckled. inspection and maintenance information 1. Switch the ignition on. Do not start the specific to the child restraint. vehicle. Ford Motor Company recommends that 2. Wait until the safety belt warning light all safety belt assemblies in use in vehicles turns off (about 1 minute). After Step involved in a crash be replaced. However, 2, wait an additional 5 seconds before if the crash was minor and an authorized proceeding with Step 3. Once you start dealer finds that the belts do not show Step 3, you must complete the damage and continue to operate properly, procedure within 30 seconds. they do not need to be replaced. Safety 3. For the seating position you are belt assemblies not in use during a crash switching off, buckle then unbuckle the should also be inspected and replaced if safety belt three times at a moderate either damage or improper operation is speed, ending in the unbuckled state. noted. After Step 3, the safety belt warning Properly care for safety belts. See Vehicle light turns on. Care (page 283). 36 Edge/Galaxy/S-MAX (CDQ) Canada/United States of America, enUSA, First Printing

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders