or
owners manual Mercedes ML
owners manual Mercedes ML - year of production: 2011, 2012, 2013, 2014, 2015 - Mercedes Benz ML Class W166 owners manual EN
Document:
pdf (6.54 MB) 458 pages
all ratings: 0
average rating: 5
text version of content this owner's manual page
from owners manual to the vehicle Mercedes ML, year of production 2011 - 2015:
Features
360
X Press and hold one of buttons ; to ? on Synchronizing the rolling code
the integrated garage door opener.
Observe the "Important safety notes"
After a short time, indicator lamp : lights
(Y page 359).
up yellow.
Your vehicle must be within reach of the
i Indicator lamp : lights up yellow as soon garage door or exterior gate drive. Make sure
that neither your vehicle nor any persons/
as button ;, = or ? is programmed for
objects are present within the sweep of the
the first time. If the selected button has
door or gate.
already been programmed, indicator
lamp : will only light up yellow after ten X
Turn the SmartKey to position 2 in the
seconds have elapsed. ignition lock.
X
Press the program button of the door or
X
Release button ;, = or ?. Indicator
gate drive (see the door or gate drive
lamp : flashes yellow.
operating instructions, e.g. under
X
Point garage door remote control A
"programming of additional remote
towards buttons ; to ? on the rear-view
controls").
mirror at a distance of 2 to 8 inches (5 to
i
Usually, you now have 30seconds to
20 cm).
initiate the next step.
i
The required distance between remote
X
Press previously programmed button ;,
res
tu
fea
control A and the integrated garage door
and
owage
St
= or ? of the integrated garage door
opener depends on the garage door drive
opener until the door closes.
system. Several attempts might be
The rolling code synchronization is then
necessary. You should test every position
complete.
for at least 25 seconds before trying
another position.
Notes on programming the remote
X
Press and hold button B on remot ec ontrol
control
A until indicator lamp : lights up green.
Canadia nr adio frequency laws require a
If indicator lamp : lights up green or
"break" (or interruption) of the transmission
flashes, then programming has been
signals after broadcasting for a few seconds.
successful.
Therefore, these signals may no tl ast long
X enough for the integrated garage door
Release button B on remote control A for
opener. The signal is no tr ecognized during
the garage door drive system.
programming. Comparable with Canadian
X
If indicator lamp : lights up red: repeat
law, some U.S.g arage door openers also
the programming procedure for the
feature a "break".
corresponding button on the rear-view
Proceed as follows:
mirror. When doing so, vary the distance
between remote control A and the rear- R
if you live in Canada
view mirror.
R
if you have difficulties programming the
garage door opener (regardless of where
i
If the indicator lamp flashes green after
you live) when using the programming
successful programming, the garage door
steps
system is using a rolling code. After
programming, you must synchronize the
garage door opener integrated in the rear-
view mirror with the receiver of the garage
door system.
Download PDF
Click here to download a pdf file with an instruction manual for Mercedes ML
year of production from: 2011
Do you prefer pdf format?
Find out how to download
Enter the code to download PDF file:
All pages in one PDF file!
How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.
:
Mercedes Benz ML Class W166 owners manual
pages 359 - 365
Mercedes Benz ML Class W166 owners manual
page 362 / 458
this site is maintained by advertising - for view instructions, turn off ad blocking in your browser
Download PDF