owners manual Nissan 370Z

all ratings: 0 average rating: 5

Black plate (360,1) . Check your local regulations. Drain plug tightening torque: (Perform steps 4 to 7 only when the engine 22 to 29 ft-lb oil filter change is needed.) (29 to 39 N·m) 4. Loosen the oil filter *2 with an oil filter Do not use excessive force. wrench. Remove the oil filter by turning it by9. Refill engine with recommended oil through hand. the oil filler opening, and install the oil filler 5. Wipe the engine oil filter mounting surface cap securely. with a clean rag. See “Capacities and recommended fuel/ lubricants” (P.9-2) for drain and refill capa- CAUTION city. The drain and refill capacity depends on the oil temperature and drain time. Use Be sure to remove any old rubber these specifications for reference only. Al- SDI2335 gasket remaining on the mounting sur- ways use the dipstick to determine the Engine oil and filter face of the engine. Failure to do so proper amount of oil in the engine. GUID-39A1DAC9-917D-40F6-9016-EB7D4F1C8886could lead to engine damage. 10. Start the engine and check for leakage 1. Place a large drain pan under the drain plug. around the drain plug and the oil filter. 2. Remove the oil filler cap. 6. Coat the gasket on the new filter with clean Correct as required. 3. Remove the drain plug *1 with a wrench engine oil. 11. Turn the engine off and wait more than 15 and completely drain the oil. 7. Screw in the oil filter clockwise until a slight minutes. Check the oil level with the dipstick. resistance is felt, then tighten additionally Add engine oil if necessary. CAUTION more than 2/3 turn. After the operation Oil filter tightening torque: GUID-3A3566B2-A3CE-4A09-8FC9-36E90C21FBBB 11 to 15 ft-lb 1. Install the engine undercover into position as Be careful not to burn yourself, as the (14.7 to 20.5 N·m) the following steps. engine oil is hot. a. Pull the center of the small plastic clip 8. Clean and re-install the drain plug with a out. . Waste oil must be disposed of newwasher. Securely tighten the drain plug properly. with a wrench. b. Hold the engine undercover into position. 8-12 Maintenance and do-it-yourself [ Edit: 2012/ 4/ 11Model: Z34-D ]

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders