BMW Z4M E86 M Power Coupe owners manual page 35

text version of content this owner's manual page from owners manual to the vehicle BMW Z4M E86, year of production 2002 - 2008:

Connector, cable and connecting hose are Stow the MMobility System in the vehicle attached to the bottom of the compressor.again. Using the M Mobility SystemDistributing sealant e To repair a flat tire with the M Mobility System, Immediately drive approx. 2 miles/3 km so that anc proceed as follows: the sealant is evenly distributed in the tire.l g > Fill sealant into wheel Do not exceed a speed of 35mph or a 60km/h. Do not drive slower than 12 mph t > Distribute sealant A > Restore tire inflation pressureor 20km/h if possible.< Filling sealant into wheelRestoring tire inflation pressure Strictly adhere to the specified order, oth-1. After approx. 2 miles/3 km, pull over at a erwise highly pressurized sealant could suitable location. escape.< 2. Screw compressor hose9 directly onto tire 1. Shake sealant bottle. valve. ls 3. Insert connector3 into cigarette lighter o 2. Screw hose9 onto connection of sealant r socket inside the vehicle.t bottle. n 3. Unscrew and remove dust cap from valve of 4. Correct tire inflation pressure to 29 psi/Co defective wheel and screw filler hose2 of 200kPa. With the ignition switched on: sealant bottle onto valve.> To increase inflation pressure: switch on 4. Insert sealant bottle on compressor hous-the compressor, position I. Switch off ing so that the bottle is in an upright posi-the device briefly to check the tire's cur- tion. rent inflation pressure.s Do not allow the compressor to run for more than 10 minutes, otherwise g tip the device will overheat and may be dam-in aged.< iv > To reduce inflation pressure: press but-r D ton 8. if the inflation pressure is not maintained, drive the vehicle again, refer to Distribut- ing sealant. Then repeat steps1 to4 once. Using the MMobility System can be ineffective 5. Make sure that the device is switched off, with tire punctures larger than approx. 1/6 in/ position 0. 4mm. Please contact the nearest BMW Center y 6. Insert connector3 into cigarette lighter or a workshop that works according to BMW ilit socket inside the vehicle.repair procedures with correspondingly trained b 7. With the ignition switched on:personnel if the tire cannot be made ready for o driving with the M Mobility System<.M Switch on the device and allow it to run for approx. 3 minutes to fill the wheel with seal-The tire inflation pressure must be at least ant. It is not important what inflation pres-29psi/200kPa. Otherwise do not con- sure the tire has after this.tinue driving.< 8. Switch off device. 9. Remove connecting hoses from connection e of sealant bottle and tire valve. c n re e 33 f Re

owners manual BMW Z4M E86

owners manual BMW Z4M E86 - year of production: 2002, 2003, 2004, 2005, 2006, 2007, 2008 - BMW Z4M E86 M Power Coupe owners manual EN