owners manual Mercedes S

all ratings: 0 average rating: 5

342 Features XPressandholdbuttonBonremotecontrol Programing Auntilindicator lamp : lights up green. Programingbuttons Whenindicator lamp : lights up green: Payattention to the "Important safety notes" programing is finished. (Y page 341). Whenindicator lamp : flashes green: programing was successful. The next step is to synchronize the rolling code. XReleasebuttonBonremotecontrolAfor the garage door drive system. If indicator lamp : lights up red: repeat the programing procedure for the corresponding button on the rear-view features mirror. When doing so, vary the distance between remote control A and the rear- and view mirror. Integrated garage door opener in the rear-view iTherequireddistancebetweenremote mirror control A and the integrated garage door Garage door remote control A is not opener depends on the garage door drive Stowageincluded with the integrated garage doorsystem. Several attempts might be opener. necessary. You should test every position for at least 25 seconds before trying XTurntheSmartKeytoposition 2 in the another position. ignition lock (Y page 171). XSelect one of buttons ; to ? to use to Synchronizing the rolling code control the garage door drive. Payattention to the "Important safety notes" XTostartprogramingmode:pressand (Y page 341). hold one of buttons ; to ? of the If the garage door systemusesarollingcode, integrated garage door opener. you will also have to synchronize the garage The garage door opener is now in door system with the integrated garage door programing mode. After a short time, openerintherear-viewmirror.Todothisyou indicator lamp : lights up yellow. will needtousetheprogramingbuttononthe XReleasebutton ;,=or?.Indicator door drive control panel. The programing button may be placed at different locations lamp :flashes yellow. depending on the manufacturer. It is usually iIndicatorlamp:lightsupyellowassoon located on the door drive unit on the garage asbutton;,=or?isprogramedforthe ceiling. first time.Iftheselectedbuttonhasalready Familiarize yourself with the garage door been programed, indicator lamp : will drive operating instructions, e.g. under only light up yellow after ten seconds have "Programing of additional remote controls", elapsed. before carrying out the following steps. XToprogramtheremotecontrol:point Your vehicle must be within reach of the garage door remote control A towards garagedoororexteriorgatedrive.Makesure buttons;to?ontherear-viewmirrorat that neither your vehicle nor any persons/ a distance of 2 to 8 inches (5 to 20 cm).objects are present within the sweep of the door or gate.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders