owners manual Mercedes GL

all ratings: 0 average rating: 5

Controls in detail Useful features Step 4: iUpon completion of programming the inte-Operation of integrated remote control  Press and hold the signal transmitter grated remote control, make sure you retain the  Switch on the ignition ( page 42). button (2, 3 or 4). Do not release hand-held remote control that came with the ga- this button until it has been successful-rage door opener, gate operator or other device.  Select and press the appropriate inte- You may need it for use in other vehicles, for fu-grated signal transmitter button (2, ly trained. ture programming of an integrated remote con-3 or4) to activate the remote con-  While still holding down the signal trol, or simply for continued use as a hand-held trolled device. transmitter button (2, 3 or 4), remote control to operate the respective device “cycle” your hand-held remote control in other situations. The integrated remote control trans- button 6 as follows: Press and hold mitter continues to send the signal as button 6 for 2 seconds, then release Reprogramming a single signal trans-long as the button is pressed – up to it for 2 seconds, and again press and mitter button 20 seconds. hold it for 2 seconds. Repeat this se-To program a device using a signal trans-Erasing the integrated remote control quence on the hand-held remote con-mitter button previously trained, follow memory trol until the frequency signal has been these steps: learned. Upon successful training,  Switch on the ignition ( page 42). Switch on the ignition ( page 42). indicator lamp1 will flash slowly and  Press and hold the desired signal  Simultaneously press and hold outer then rapidly after several seconds.transmitter button (2, 3 or 4). signal transmitter buttons 2 and 4,  Proceed with programming step 5 and Donot release the button.for approximately 20 seconds, until step 6 to complete. indicator lamp 1 flashes rapidly. Do  Indicator lamp1 will begin to flash af-not hold for longer than 30 seconds. ter 20 seconds. Without releasing the The codes of all three channels are signal transmitter button, proceed with erased. programming starting with step 3. iIf you sell your vehicle, erase the codes of all three channels. 343

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders