owners manual Mercedes GL

all ratings: 0 average rating: 5

Controls in detail Useful features Step 2: Step 3: Step 5:  If you have previously programmed a  Hold end of the hand-held remote  After indicator lamp 1 changes from a signal transmitter button and wish to control 5 of the device you wish to slow to a rapidly flashing light, release retain its programming, proceed to train approximately 2 to 5 in the hand-held remote control button step 3. (5 to 12 cm) away from the signal and the signal transmitter button. If you are programming the integrated transmitter button (2, 3 or 4) to be Step 6: remote control for the first time, press programmed, while keeping the indica- and hold the two outer signal transmit-tor lamp 1 in view. Press and hold the just-trained signal ter buttons 2 and 4 and release Step 4: transmitter button (2, 3 or 4) and them only when indicator lamp 1 observe indicator lamp 1. begins to flash after approximately  Using both hands, simultaneously If indicator lamp 1 stays on 20seconds (do not hold the button for press hand-held remote control constantly, programming is complete longer than 30 seconds). This proce-button 6 and the desired signal trans-and your device should activate when dure erases any previous settings for mitter button (2, 3 or 4). Do not the respective signal transmitter all three channels and initializes the release the buttons until step 5 is com-button (2, 3 or 4) is pressed and re- memory. pleted. leased. If you later wish to program a second Indicator lamp 1 will flash, first slowly iIf indicator lamp 1 flashes rapidly for about and/or third hand-held transmitter to and then rapidly.2seconds and then turns to a constant light, the remaining two signal transmitter iIndicator lamp 1 flashes immediately the continue with programming steps 8 through 12 buttons, do not repeat this step and be-first time the signal transmitter button is as your garage door opener may be equipped gin directly with step 3.programmed. If this button has already been with the “rolling code” feature. programmed, the indicator lamp will only start flashing after 20 seconds. 341

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders