owners manual Mercedes E

all ratings: 0 average rating: 5

212_AKB; 2; 41, en-US 2009-07-17T09:14:21+02:00 - Seite 333 d2ureepe, Version: 2.11.8.1 ® AdBlue (diesel engine only) 333 Version 1: Open vent screw F on XReturn the SmartKey in the starter switch pressure gauge G (Y page 331). to position 0. XTurn the SmartKey in the starter switch to Version 2: Press yellow deflate button a position 3 and hold it there for a maximum located in air pump housing next to of 10 seconds or until the engine runs pressure gauge G. surge-free. XDrive to the nearest qualified workshop, If the engine does not start: e.g. an authorized Mercedes-Benz Center, XTurn the SmartKey in the starter switch to have the damaged tire replaced. once more to position 2 for at least XRecommended duration of use: A 10 seconds. maximum of 300 miles (500 km) at 50 mph XReturn the SmartKey in the starter switch (80 km/h) or below with the recommended to position 0. tire inflation pressure. XTurn the SmartKey in the starter switch XContact an authorized Mercedes-Benz once more to position 3 and hold it there Center as soon as possible to obtain a new for a maximum of 10 seconds or until the TIREFIT kit. engine runs surge-free. XBring used TIREFIT materials to an XIf necessary, repeat the above steps. authorized Mercedes-Benz Center for proper disposal. If the engine still does not start after 3 attempts: Practical hints XReplace your TIREFIT container every 4 years. Replacement containers areDo not make any further attempts to start the available at any authorized Mercedes-Benzengine. Contact an authorized Mercedes- Center. Benz Center or call Roadside Assistance (Y page 210). iWhen the malfunction indicator Bleeding the fuel system (diesel lamp ; in the instrument cluster has engine only) been illuminated for the above condition, it will remain illuminated until the engine was Driving the vehicle until the fuel tank is empty cycled on and off four times in a row. is not recommended. Otherwise, air may be sucked into the fuel system. If this happens, the malfunction indicator lamp ; comes ® AdBlue (diesel engine only) on and the engine may not start immediately after refueling the vehicle. The BlueTEC exhaust gas aftertreatment After refueling: ® system requires a reducing agent (AdBlue ) XMake sure the automatic transmission is inin order to function properly. Refilling with ® park position P. AdBlue is part of the regular maintenance ® The transmission position indicator in the service work. A tankful of AdBlue should multifunction display should be on P. suffice until the next maintenance service XDo not depress the accelerator. under normal driving conditions. ® XIf necessary, remove the KEYLESS-GOWhen the AdBlue tank is low, the message start/stop button from the starter switch.Check Additive See Operator’s X Manual appears in the multifunction display. Turn the SmartKey in the starter switch to ® position 2 for at least 10 seconds. When the AdBlue level drops to the minimum level, the message Remaining Z

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders