owners manual Mercedes E

all ratings: 0 average rating: 5

212_AKB; 2; 41, en-US 2009-07-17T09:14:21+02:00 - Seite 332 d2ureepe, Version: 2.11.8.1 332 Flat tire You may operate the air pump again after GWarning! it has cooled off. Do not exceed a vehicle speed of 50 mph (80 km/h). A TIREFIT repair is not designed to If the tire inflation pressure of at least operate at higher speeds. 26 psi (1.8 bar) is not attained: The sticker must be attached on the XTurn off the electric air pump by pressing instrument cluster where it will be easily seen 0 on electric air pump switch =. by the driver. XDetach filler hose D from tire valve E. Vehicle handling characteristics of a TIREFIT XDrive vehicle back or forth very slowly repaired tire may change. Adapt your driving approximately 30 ft (10 m). accordingly. This serves to better distribute the TIREFIT sealant material inside the tire.X After driving the vehicle for an initial XInflate the tire again. 10 minutes, check the tire inflation pressure using the pressure gauge. GWarning! GWarning! If a tire inflation pressure of 26 psi (1.8 bar) is not attained, the tire is too severelyIf tire inflation pressure has fallen below damaged for TIREFIT to provide a reliable tire20 psi (1.3 bar) do not continue to drive the repair. vehicle. Practical hints In this case, TIREFIT cannot properly seal thePark your vehicle safely away from the tire. roadway and contact the nearest authorized Mercedes-Benz Center or Roadside Do not drive the vehicle. Assistance. Contact the nearest Mercedes-Benz Center or Have the damaged tire replaced. call Roadside Assistance. If the tire inflation pressure is at least 20 psi After attaining a tire inflation pressure of (1.3 bar), inflate or deflate the tire to the at least 26 psi (1.8 bar): correct tire inflation pressure (see Tire and XPress 0 on electric air pump switch =. Loading Information placard on the driver’s The electric air pump is switched off. door B-pillar): XDetach the TIREFIT kit from the tire valve. GWarning! The air hose may still be hot. Exercise proper caution to avoid burning yourself when detaching the electric air pump. ! Remaining TIREFIT sealant could escape from the filler hose after it has been detached from the tire valve. TIREFIT sealant may cause stains. Therefore, cover the filler hose, e.g. byVersion 2 inserting it into the plastic bag the TIREFIT XTo increase tire inflation pressure: kit was packed in. Switch on the electric air pump. XTo decrease tire inflation pressure: XDrive off immediately.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders