owners manual Mercedes E

all ratings: 0 average rating: 5

Controls in detail Useful features iUpon completion of programming the inte-Operation of integrated remote controlProgramming tips grated remote control, make sure you retain the  Switch on the ignition ( page 37).If you are having difficulty programming hand-held remote control that came with the ga- the integrated remote control, here are rage door opener, gate operator or other device.  Select and press the appropriate inte-some helpful tips: You may need it for use in other vehicles, for fu-grated signal transmitter button (2, ture programming of an integrated remote con-3 or4) to activate the remote con-
Check the frequency of hand-held re- trol, or simply for continued use as a hand-held trolled device.mote control5 (typically located on remote control to operate the respective device the reverse side of the remote). The in- in other situations. The integrated remote control trans-tegrated remote control is compatible mitter continues to send the signal as with radio-frequency devices operating Reprogramming a single signal trans-long as the button is pressed – up to between 280-390 MHz. mitter button 20seconds. To program a device using a signal trans-
Put a new battery in hand-held remote mitter button previously trained, follow Erasing the integrated remote control control5. This will increase the likeli- these steps: memory hood of the hand-held remote control  Switch on the ignition ( page 37).sending a faster and more accurate sig-  Switch on the ignition ( page 37). nal to the integrated remote control.  Press and hold the desired signal  Simultaneously press and hold outer
While performing step 3, hold transmitter button (2, 3 or 4). signal transmitter buttons2 and 4, hand-held remote control5 at differ- Donot release the button. for approximately 20 seconds, until ent lengths and angles from the signal indicator lamp 1 flashes rapidly. Do transmitter button (2, 3 or 4) you  Indicator lamp1 will begin to flash af-not hold for longer than 30 seconds. ter 20 seconds. Without releasing the are programming. Attempt varying an- signal transmitter button, proceed with The codes of all three channels are gles at the distance of 2 to 5 inches programming starting with step 3.erased. (5 to 12 cm) away or the same angle at iIf you sell your vehicle, erase the codes of all varying distances. three channels. 305

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders