owners manual Mercedes E

all ratings: 0 average rating: 5

Controls in detail Useful features Step 3: Step 5: Rolling code programming  Hold the end of hand-held remote  After indicator lamp 1 changes from a To train a garage door opener (or other control 5 of the device you wish to slow to a rapidly flashing light, release rolling code devices) with the rolling code train approximately 2 to 5 in the hand-held remote control button feature, follow these instructions after (5 to 12 cm) away from the signal and the signal transmitter button.completing the “Programming” portion transmitter button ( 2, 3 or 4) to be Step 6: (steps 1 through 6) of this text. (A second programmed, while keeping the indica- person may make the following training tor lamp 1 in view.  Press and hold the just-trained signal procedures quicker and easier.) Step 4: transmitter button (2, 3 or 4) and Step 8: observe the indicator lamp1.  Using both hands, simultaneously If indicator lamp1 stays on  Locate “training” button on the garage press hand-held remote control constantly, programming is complete door opener motor head unit. button 6 and the desired signal trans-and your device should activate when Exact location and color of the button mitter button (2, 3 or 4). Do not the respective signal transmitter may vary by garage door opener brand. release the buttons until step 5 is com-button (2, 3 or 4) is pressed and re-Depending on manufacturer, the pleted. leased. “training” button may also be referred Indicator lamp 1 will flash, first slowly iIf indicator lamp 1 flashes rapidly for about to as “learn”or “smart” button. If there and then rapidly. 2seconds and then turns to a constant light, is difficulty locating the transmitting iIndicator lamp 1 flashes immediately the continue with programming steps 8 through 12 button, refer to the garage door opener first time the signal transmitter button is pro-as your garage door opener may be equipped Operators Manual.  grammed. If this button has already been pro-with the “rolling code” feature. grammed, the indicator lamp will only start Step 7: flashing after 20 seconds.  To program the remaining two signal transmitter buttons, repeat the steps above starting with step 3. 303

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders