owners manual Audi A4

all ratings: 6 average rating: 5

document_0900452a81b1b9de.book Seite 293 Donnerstag, 26. Juli 2007 9:16 09 Self-help 293 – Insert the hook (provided in the vehicle's tool kit) in the Jump leads hole in the hub cap. The jump leads must be heavy enough to carry the starter current. –Pull off thehub c ap ⇒page289, fig. 271. Refer to the details given by the manufacturer. Only use jump leads with insulated battery clamps. 2 1 – Insert the adapter A completely into the wheel bolt A .Positive cable – usually red 2 – Fit the box spanner as far as it will go over the adapter . A Negative cable – usually black – Loosen or tighten the wheel bolt ⇒ page 289. It is advisable to carry the wheel bolt adapter in the vehicle. The WARNING adapter is normally stored in the vehicle tool kit, underneath the • When it is discharged the battery can freeze at temperatures towline anchorage. It should be put back there after use.around0°C. A frozen battery must first be thawed out before The code number of the anti-theft wheel bolt is stamped on the front connecting the jump leads, as it could otherwise explode. of the adapter. Your Audi dealer will need this number to replace the • Please note the safety warnings referring to working in the adapter if lost. engine compartment ⇒page255. Note Note Note the code number of the anti-theft wheel bolt and keep it in a • There must be no contact between the two vehicles as otherwise safe place – not in your vehicle. current could flow as soon as the positive terminals are connected. • The discharged battery must be properly connected to the Jump-starting vehicle's electrical system. • Switch off the car telephone if necessary. Details will be given in the manufacturer's instructions for the car telephone. Before starting the engine If necessary, the engine can be started by connecting it to the battery of another vehicle. If the engine should ever fail to start because of a discharged battery, the battery can be connected to the battery of another vehicle to start the engine. Suitable jump leads are required. Both batteries must be rated at 12 Volts. The capacity (Ah) of the booster battery should not be significantly lower than that of the discharged battery. Controls Safety Driving tips General maintenance Self-help Technical data

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders