owners manual Subaru Outback

all ratings: 0 average rating: 5

Starting and operating7-13 &Entering the vehicle follow-&Service mode &Remotetransmitter program ing remote engine start shut-In service mode, the remote engine startNew transmitters can be programmed to down function is temporarily disabled to preventthe remote engine start system in the Analarmtriggermayoccurifthevehicleisthe system from unexpectedly starting theevent that a transmitter is lost, stolen, opened by the remote keyless entry engine while being serviced.damaged or additional transmitters are transmitter within a few seconds immedi-To engage or disengage service mode:desired (the system will accept up to eight ately following remote engine start shut- transmitters). New remote engine start down. 1. Enter the vehicle and close all vehicletransmitters can be programmed accord- doors and the trunk/rear gate.ing to the following procedure. &Pre-heating or pre-cooling 2. Verify that the select lever is in the “P” position (AT and CVT models) 1. Open the driver’s door (the driver’s the interior of the vehicle3. Depress and hold the brake pedaldoor must remain opened throughout the Models with automatic climate control4. Turn the ignition switch to the “ON”entire process). system: position 2. Depress and hold the brake pedal. After the system starts the engine, the5. Press and release the remote engine3. Turn the ignition switch to “ON” then automatic climate control system will ” button three times.“LOCK”, back to “ON” then “LOCK”, then activate the “FULL AUTO” mode and heatstart transmitter “ back to “ON” again and leave the ignition or cool the interior to the predeterminedThe system will honk the vehicle’s horn“ON” throughout the programming pro- each time the button is pressed.cess. median (room) temperature. No pre- setting of controls is necessary.6. The system will pause for 1 second4. The system will flash the side marker then honk the vehicle’s horn three times tolights, tail lights and front position lights Models without automatic climate con-indicate that the service mode has beenand honk the horn three times, indicating trol system: engaged or honk one time to indicate thatthat the system has entered the transmit- Before exiting the vehicle, set the tem-the service mode has been disengaged.ter learn mode. perature controls to the desired setting 5. Press and release the “ ” button on and operation. After the system starts theNOTE the transmitter that you want to program. engine, the heater or air conditioning willWhentakingyourvehicleinforservice, activate and heat or cool the interior to 6. The system will flash the side marker your setting. it is recommended that you inform thelights, tail lights and front position lights service personnel that your vehicle isandhonkthehornonetime,indicatingthat equipped with a remote engine startthe system has learned the transmitter. system. Upon successful programming, the re- mote start confirmation transmitter button – CONTINUED –

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders