owners manual Nissan Micra

all ratings: 0 average rating: 5

Black plate (279,1) Engine oil and filter replacement (K9K engine 7. Apply new engine oil to the gasket on the new oild. Screw in the bolts, then tighten them. model) filter. 2. Lower the vehicle carefully to the ground. GUID-DB83B48C-F30F-4EEF-B4C0-FD3B0797231A 8. Screwintheoil filter until a slight resistance is felt,PROTECT ENVIRONMENT and then tighten an additional 3/4 of a turn to GUID-70D58191-654F-487A-A9F7-F0B9E1A5A11B secure the filter. It is illegal to pollute drains, watercourses and soil. Use Oil filter tightening torque: authorized waste collection facilities, including civil 16to20N·m(1.6to2.0kg-m,12to15ft-lb) amenity sites and garages providing facilities for disposal of used oil and used oil filters. If in doubt, 9. Cleanandreinstall the drain plug and new washer.contact your local authority for advice on disposal. Securely tighten the drain plug with a wrench. DoThe regulations concerning the pollution of the not use excessive force. environment will vary from country to country. Drain plug tightening torque: 16to24N·m(1.6to2.4kg-m,12to18ft-lb) SDI2472 1. Oil drain plug 10. Refill the recommended engine oil and quantity. 2. Oil filter (See “Recommended fuel/lubricants and capaci- ties” (P.9-2).) 1. Place a large drain pan under the drain plug.11. Securely install the oil filler cap. 2. Remove the drain plug with a wrench. 12. Start the engine. 3. Remove the oil filler cap and completely drain the13. Check the drain plug and the oil filter for any sign oil. of leakage. Ifthe oil filter is to be changed, remove and14. Dispose of the used oil in the proper manner. replace it at this time. Check your local regulations. CAUTION: 15. Check the engine oil level according to the proper procedure. (See “Checking engine oil level” (P.8- Waste oil must be disposed of properly. Check 11).) your local regulations. After operation 4. Loosen the oil filter with an oil filter wrench. GUID-B636D33D-2A55-4466-A417-154FB64E0B77 1. Install the engine undercover (if removed) into 5. Remove the oil filter by turning it by hand. position as the following steps. 6. Wipe the entire oil filter mounting surface with aa. Pull the center of each plastic clip out. clean cloth. b. Hold the engine undercover into position. Besuretoremoveanyoldgasketremainingonthe c. Insert the clips through the undercover into the mounting surface. hole in the frame, then push the center of the clips in to lock the clips in place. Maintenance and do-it-yourself 8-15 Condition: [ Edit: 2013/ 2/ 25Model: K13-A ]

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders