owners manual Mitsubishi Eclipse

owners manual Mitsubishi Eclipse - year of production: 1995, 1996, 1997, 1998, 1999 - Mitsubishi Eclipse II technical information manual EN

Document: pdf (13.48 MB) 381 pages

all ratings: 0 average rating: 5

text version of content this owner's manual page from owners manual to the vehicle Mitsubishi Eclipse, year of production 1995 - 1999:

3-58 DRIVE-CONTROL COMPONENTS- ABS 2. Diagnostic Trouble Code Indication Method Diagnostic trouble codes are indicated as described below, depending on failure conditions in the system. ‘d System failure condition Display on scan tool Display by voltmeter No failure detected in the past No diagnostic trouble code displayed. ON/OFF at 0.5 sec. intervals (no-failure code) Failure detected in the All codes associated with the failures that past All codes associated with the failures that occurred in the past are displayed,begin- occurred in the past are displayed, begin- ning with the most recent one. ning with the most recent one. NOTE Even if failures of a same code repeatedly occur, the code that is displayed is the one stored for the first time only, 3. Diagnostic Trouble Code Clearing Procedure Clear the memory according to the message that (2) To check whether the memory has been cleared, appears on the scan tool. (For details, refer to the instruction manual for the scan tool.) the diagnostic trouble code reading procedure should be performed. NOTE (3) Even after the memory has been cleared, an instruction from the scan tool can be accepted. (1) When the ABS-ECU system is out of order, the diagnostic trouble codes in the memory can- To confirm a diagnosis code, the scan tool not be cleared by use of the scan tool. should be re-operated. Actuator Test The actuator can be force-driven using the scan tool for easy operation inspection, actuator testing exceedsIO km/h (6 mph), forced actuation will be cancelled. Lj NOTE (3) The following item numbers are those to be entered on the scan tool to give an actuator (1) If the ABS-ECU function has been cancelled, an actuator test cannot be performed. test instruction. (2) Actuator testing is only possible when the ve- hicle is stationary. If the vehicle speed during Item No. Drive object Drive pattern 04 F.R. solenoid valve and pump motor Increase in Solenoid valve ;;;ij’ijiq+r 05 F.L. solenoid valve 44 ms 3sec. I and pump motor ;;; ,9”: I1 *ms Start of forced actuation End of forced actuation 14AO588

Download PDF

Click here to download a pdf file with an instruction manual for Mitsubishi Eclipse
year of production from: 1995

Do you prefer pdf format?
Find out how to download

Enter the code to download PDF file:

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.