manual Mercedes Benz R Class owners manual page 277

text version of content this owner's manual page from owners manual to the vehicle Mercedes R, year of production 2005 - 2013:

BA 251 USA, CA Edition A 2011; 1; 3, en-US2010-04-16T14:31:55+02:00 - Seite 275 d2sboike Version: 3.0.3.5 Features 275 the setup has been completed make sure that new batteries have been successfully. installed in the garage door remote control. X R At the same time, press transmitter buttonAlign the antenna cable of the garage door B of the garage door remote control foropener unit. This can improve signal two seconds, then release it for tworeception/transmission. seconds, then press it again for two seconds. Opening or closing the garage door XRepeat this sequence on transmitter Once programmed, the integrated remote button B of the garage door remote control will assume the function of the garage control until the frequency signal has been door system's remote control. Please also saved. read the operating instructions for the garage XIf the setup procedure is successful, door system. indicator lamp : flashes once slowly and XTurn the SmartKey to position 2 in the goes out after a few seconds. ignition lock. XContinue with the other programming XPress transmitter button ;, = or ? in the steps (see above). overhead control panel that you have programmed to operate the garage door. Problems when programming Garage door system with fixed code: If you have problems when programming the indicator lamp : lights up continuously.Loading, stowing and features integrated remote control, please note the Garage door system with rolling code: following: indicator lamp : flashes briefly and then R Check the transmitter frequency of garage lights up for approximately two seconds. door remote control A (which can usually This is repeated for up to 20 seconds. be found on the rear of the remote control). iThe transmitter will transmit a signal for The integrated remote control is as long as the transmitter button is being compatible with devices that operate at pressed. The transmission will be halted frequencies between 280 and 390 MHz. after a maximum of 20 seconds and R Replace the batteries in garage door indicator lamp : will flash. Press the remote control A. This increases the transmitter button again, if necessary. likelihood of garage door remote control A sending a strong and precise Clearing the remote control memory signal to the integrated remote control on XTurn the SmartKey to position 2 in the the rear-view mirror. ignition lock. R When programming, hold garage door XPress and hold transmitter buttons ; remote control A at varying distances and and ? for approximately 20 seconds until angles from the transmitter button which indicator lamp : flashes rapidly. you are programming. Try different angles The memory is cleared. at a distance of 2 to 12 inches (5 to 30 cm) or the same angle at different distances. iYou should clear the remote control R If there is another garage door remote memory before selling the vehicle. control for the same device, perform the programming steps again using the remote control. Before performing these steps, Z

owners manual Mercedes R

owners manual Mercedes R - year of production: 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013 - Mercedes Benz R Class owners manual EN