manual Mercedes Benz R Class owners manual page 276

text version of content this owner's manual page from owners manual to the vehicle Mercedes R, year of production 2005 - 2013:

BA 251 USA, CA Edition A 2011; 1; 3, en-US2010-04-16T14:31:55+02:00 - Seite 274 d2sboike Version: 3.0.3.5 274 Features iTo achieve the best result, insert newIf indicator lamp : goes out after batteries in garage door remote controlapproximately 20 seconds and has not A of your garage door drive beforeflashed rapidly: programming. XRelease transmitter buttons ;, = or ? XErase the memory of the integrated remoteon the integrated remote control and control (Y page 275) before programmingtransmitter button B on the garage door it for the first time. remote control. XTurn the key to position 2 in the ignitionX Repeat the procedure for the other lock. transmitter buttons. When doing so, vary X the distance between the garage door's Press and hold one of transmitter remote control and the transmitter buttons buttons ; to ? on the integrated remote in the rear-view mirror. control. After a short time, indicator lamp : will iIf the garage door system works with a start flashing. It flashes about once per rolling code, you must synchronize the second. remote control integrated into the rear- iIndicator lamp : flashes immediately view mirror with the garage door system the first time that the transmitter button is receiver after programming. programmed. If this transmitter button has You will find further information in the Loading, stowing and featuresalready been programmed, indicator garage door opening system's operating lamp : will only start flashing at a rate of instructions, e.g. the sections on once per second after 20 seconds have "Synchronizing the transmitter" or elapsed. "Registering a new transmitter". You can X also call the hotline mentioned above. Keep the transmitter button depressed. XPoint transmitter button B of garage door Notes on programming the remote remote control A towards the transmitter control buttons on the rear-view mirror at a Canadian radio frequency laws require a distance of 2 to 12 inches (5 to 20 cm). "break" (or interruption) of the transmission iThe distance between garage door signals a few seconds after broadcasting. remote control A and the integrated Therefore, these signals may not last long garage door opener depends on the system enough for the integrated remote control to of the garage door drive. You might require recognize the signal during programming. several attempts. You should test every Comparable with Canadian law, some U.S. position for at least 20 seconds before garage door openers also have a built-in trying another position. "interruption". XKeep transmitter button B on garage doorIf you live in Canada or have difficulties programming the garage door opener remote control A pressed until indicator (regardless of where you live) when using the lamp : starts to flash rapidly. programming steps (see above), proceed as The programming has been successful if follows: indicator lamp : flashes rapidly. XPress transmitter button (;, = or ?) and XRelease transmitter buttons ;, = or ? hold it down during the following steps until on the integrated remote control and transmitter button B on the garage door remote control.

owners manual Mercedes R

owners manual Mercedes R - year of production: 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013 - Mercedes Benz R Class owners manual EN