Nissan X Trail T30 I 1 owners manual page 271

text version of content this owner's manual page from owners manual to the vehicle Nissan X-Trail, year of production 2001 - 2009:

EVENT DATA RECORDERS the battery is disconnected, the vehicle may bethen quickly release the accelerator pedalYour vehicle is equipped with a variety of com- reset to a not “ready condition”. Before takingcompletely and keep it released for at leastputers that monitor and control a number of the I/M test, check the vehicle’s inspection/10 seconds.systems to optimize performance and help ser- maintenance test readiness condition. Turn the3. Quickly depress the accelerator pedal for avice technicians with diagnosis and repair. De- ignition switch ON without starting the engine. Ifmoment, then drive the vehicle at a speed ofpendingontheequipmentonyourvehicle,some the Malfunction Indicator Lamp (MIL) comes on86 to 96 km/h (53 to 60 MPH) for at least 9of the computers monitor emission control sys- steady for 20 seconds and then blinks for 10minutes. tems, braking systems, engine systems, trans- seconds, the I/M test condition is “not ready”. If mission systems, tire pressure systems, and air the MIL does not blink after 20 seconds, the I/M4. Stop the vehicle. Leave the engine running.bag systems, just to name a few. Some data test condition is “ready”. 5. Accelerate the vehicle to 55 km/h (35 MPH)about vehicle operation may be stored in the and maintain the speed for 20 seconds.computers for use during servicing. Other data If the MIL indicates the vehicle is in a “not ready” may be stored if a crash event occurs. For condition, drive the vehicle through the following6. Repeat steps 4 and 5 at least 10 times.example, air bag readiness, air bag performance, pattern to set the vehicle to the ready condition.7. Accelerate the vehicle to 88 km/h (55 MPH)andseatbeltusebythedriverorpassengermay Ifyou cannot or do not want to perform theandmaintainthespeedforatleast3minutes.be recorded, depending on vehicle equipment. driving pattern, a NISSAN dealer can conduct it These types of systems are sometimes called for you. 8. Stop the vehicle. Place the transmission se-Event Data Recorders. lector lever in the “P” or “N” position.Special equipment can be used to access the WARNING 9. Turn the engine off. electronic data that may be stored in the vehi- 10. Repeat steps 1 through 8 at least one morecle’s computers (sounds are not recorded). Always drive the vehicle in a safe andtime. NISSAN and NISSAN dealers have equipment prudent manner according to traffic to access some of this data; others may also conditions, and obey all traffic laws.Ifstep 1 through 7 is interrupted, repeat thehave this equipment. The data may be retrieved preceding step. Any safe driving mode is ac-during routine vehicle servicing or for special ceptable between steps. Do not stop the engineresearch. It might also be accessed with the 1. Start the engine. Allow the engine to idle untiluntil step 7 is completed.consent of the vehicle owner or lessee, in re- theenginecoolanttemperaturegaugeneedle sponse to a request by law enforcement, or as points between the C and H (normal operat- otherwise required or permitted by law. ing temperature). 2. Accelerate the vehicle to 88 km/h (55 MPH), 9-24 Technical and consumer information 06.4.14/T30-J/V5.0

owners manual Nissan X-Trail

owners manual Nissan X-Trail - year of production: 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009 - Nissan X Trail T30 I 1 owners manual EN