Using the Digit Dial CommandUsing the Call Command
1. Press and hold b g for two seconds. The system1. Press and hold b g for two seconds. The system
responds with “Ready” followed by a tone.responds with “Ready” followed by a tone.
2. Say “Digit Dial”. The system responds with “Digit2. Say “Call”. The system responds with “Call using
dial using
, please say the first digit. Please say the name tag” followed
to dial” followed by a tone.by a tone.
3. Say the digit to be dialed one at a time. Following3. Say the name tag of the person to call.
each digit, the system will repeat back the digit it• If the system clearly recognizes the name tag it
heard followed by a tone. responds with “OK, calling, ” and
4. Continue entering digits until the number to bedials the number.
dialed is complete. After the whole number has• If the system is unsure it recognizes the right
been entered, say “Dial”. The system responds withname tag, it confirms the name tag followed
“OK, Dialing” and dials the number.by a tone. If the name tag is correct, say
• If an unwanted number is recognized by the“Yes”. The system responds with “OK, calling,
system, say “Clear” at any time to clear the” and dials the number. If the
last number. name tag is not correct, say “No”. The system
• To hear all of the numbers recognized by thewill ask for the name tag to be re-entered.
system, say “Verify” at any time and theOnce connected, the person called will be heard
system will repeat them.through the audio speakers.
4-99