owners manual Skoda Octavia

all ratings: 0 average rating: 5

20A5Facelift.book Page 248 Saturday, September 6, 2008 2:13 PM 248 Breakdown assistance WARNING (continued) – Tighten the wheel bolts firmly, alternately and diagonally using the wheel wrench (crosswise) and last the safety wheel bolt* ⇒ page 250. provisions. In this way you are protecting not only yourself but also other road users. – Mount the full wheel trim/wheel trim cap or the caps. • Never start the engine with the vehicle sitting on the raised jack - danger of suffering injury. Note • All bolts must be clean and must turn easily. Caution • You must never grease or oil the wheel bolts! If you have to change a wheel on a slope first block the opposite wheel with a stone • When fitting on unidirectional tyres, ensure that the tyres rotate in the correct or similar object in order to secure the vehicle from unexpectedly rolling away.direction ⇒page237. Note Subsequent steps Comply with the national legal regulations. After changing the wheel, you must perform the following steps. Changing a wheel – Stow and attach the replaced wheel in the spare wheel well. Always change a wheel on a level surface as far as possible.– Stow the vehicle tool kit in the space provided. – Take off the full wheel trim* ⇒ page 249 or the caps ⇒ page 249.– Check the tyre pressure on the spare wheel just mounted as soon as possible. – In the case of light alloy wheels remove the wheel trim cap – Have the tightening torque of the wheel bolts checked with a torque ⇒page250. wrench as soon as possible. Steel and light alloy wheels must be tight- – First of all slacken the safety wheel bolt * and afterwards the other ened to a tightening torque of 120 Nm. wheel bolts ⇒page250. – Have the defective tyre repaired as soon as possible. – Jack up the vehicle until the wheel to be changed is clear of the ground ⇒page251. WARNING – Unscrew the wheel bolts and place them on a clean surface (cloth, It is necessary to observe the guidelines given on ⇒page239 if the vehicle is paper etc.). subsequently fitted with tyres which are different to those it was fitted with – Take off the wheel. at the works. – Fit on the spare wheel and tighten the wheel bolts slightly. –Lower the car.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders