owners manual Seat Leon

all ratings: 0 average rating: 5

leon_EN.book Seite 235 Donnerstag, 15. April 2010 9:19 09 Wheels and tyres235 2. The tyre pressures should only be checked when the tyres are Tyre pressure monitoring cold. The slightly raised pressures of warm tyres must not be The tyre pressure monitoring system constantly checks the reduced. pressure of the tyres. 3. Adjust the tyre pressure to the load you are carrying. The system uses the speed sensors of the ABS wheels. It operates by Tyre pressure analysing the speed and frequency spectrum of each wheel. The correct tyre pressure is especially important at high speeds. The pressure For optimum performance, use genuine SEAT tyres. In addition, check and should therefore be checked at least once a month and before starting a adjust tyre pressures regularly. journey. Whenever the tyre pressures are changed or one or more tyres are changed, The sticker with the tyre pressure values can be found on the inside of the the system should be Reset by pressing the SET switch on the centre console. tank flap. The tyre pressure values given are for cold tyres. Do not reduce the The system warns the driver in the event of a loss of pressure by means of slightly raised pressures of warm tyres ⇒. symbols and messages in the instrument panel display. The system uses ESP ⇒page185. WARNING Note that tyre pressure also depends on tyre temperature. Tyre pressure • Check the tyre pressure at least once per month. Checking tyre pressure increases about 0.1 bar for each 10°C in tyre temperature increase. The tyre value is very important. If the tyre pressure is too high or too low, there is heats up while the vehicle is being driven and the tyre pressure will rise an increased danger of accidents - particularly at high speeds.accordingly. For this reason, you should only adjust the tyre pressures when • A tyre can easily burst if the pressure is too low, causing an accident!they are cold (i.e. approximately at ambient temperature). • At continuously high speeds, a tyre with insufficient pressure flexes To ensure that the tyre pressure monitoring system works reliably, you should more. In this way it becomes too hot, and this can cause tread separation check and, if necessary, adjust the tyre pressures at regular intervals and and tyre blow-out. Always observe the recommended tyre pressures.store the correct pressures (reference values) in the system. • If the tyre pressure is too low or too high, the tyres will wear prema-A tyre pressure information label is attached to the inside of the fuel tank flap. turely and the vehicle will not handle well. Risk of accident! WARNING For the sake of the environment • Never adjust tyre pressure when the tyres are hot. This may damage or Under-inflated tyres will increase fuel consumption.even burst the tyres. Risk of accident! • An insufficiently inflated tyre flexes a lot more at high speeds and causes significant heating of the tyre. Under these conditions, the tyre bead may be released or the tyre may burst. Risk of accident! Safety first Operating instructions Practical tips Technical data

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders