owners manual Mercedes C

all ratings: 0 average rating: 5

BA 204 USA, CA Edition A 2011; 1; 5, en-US2010-05-20T09:17:30+02:00 - Seite 234 hereepe Version: 3.0.3.6 234 Features R not be long enough for the integrated signalWhen aiming the garage door remote transmitter to pick up the signal duringcontrol at the transmitter buttons on the programming. Similar to this Canadian law,rear-view mirror, hold garage door remote some U.S. gate operators are designed tocontrol A at differing distances and angles "time-out" in the same manner. from the transmitter button that you are programming. Try different angles from a If you live in Canada or have difficulties distance of 2 to 12 inches (5 to 30 cm) or programming the garage door opener the same angle from differing distances. (regardless of where you live) when using the programming steps (see above), proceed asR If there is another garage door remote follows: control for the same device, perform the programming steps again using the remote XPress transmitter button (;, = or ?) and control. Before performing these steps, hold it down during the following steps until make sure that new batteries have been the setup has been completed installed in the garage door remote control. successfully. R Align the antenna cable of the garage door XAt the same time, press transmitter button opener unit. This can improve signal B of the garage door remote control for reception/transmission. two seconds, then release it for two seconds, then press it again for two Opening or closing the garage door seconds. Loading, stowing and features XRepeat this sequence on transmitter Once programmed, the integrated remote button B of the garage door remotecontrol will assume the function of the garage control until the frequency signal has beendoor system's remote control. Please also learned. read the operating instructions for the garage door system. XIf the setup procedure is successful, indicator lamp : flashes once slowly andXTurn the SmartKey to position 2 in the goes out after a few seconds. ignition lock. XContinue with the other programmingXPress transmitter button ;, = or ? in the steps (see above). overhead control panel that you have programmed to operate the garage door. Problems when programming Garage door system with fixed code: If you have problems when programming theindicator lamp : lights up continuously. integrated remote control, please note the Garage door system with rolling code: following: indicator lamp : flashes briefly and then R check the transmitter frequency of garagelights up for approximately two seconds. door remote control A (which can usuallyThis is repeated for up to 20 seconds. be found on the rear of the remote control). iThe transmitter will transmit a signal for The integrated remote control isas long as the transmitter button is being compatible with equipment that operatespressed. The transmission will be halted in the frequency range 280 to 390 MHz.after a maximum of 20 seconds and R indicator lamp : will flash. Press the replace the batteries in garage door remote control A. This increases the likelihood oftransmitter button again, if necessary. garage door remote control A sending a strong and precise signal to the integrated remote control on the rear-view mirror.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders