owners manual Seat Ateca

all ratings: 0 average rating: 5

Driver assistance systems and rear bumpers, the  ››› Fig. 200 button with the operation of the Park Assist systemNote a to switch the system on and off and the mes-at and cause damage. ● In order to guarantee good system opera- d sages on the instrument panel display. ● al The Park Assist system uses as a reference tion, keep the ultrasound sensors of the parked vehicles, curbs and other objects. bumper clean, free of snow or ice, and do not hnic Prematurely stopping or automatically inter- Make sure that the tyres and wheels are not cover them with adhesives or other objects. ec T rupting the manoeuvres for parking or exit- damaged while parking. If necessary, oppor- ● Certain sources of noise, such as rough as- tunely interrupt the parking manoeuvre to ing a parking space phalt or paving stones and the noise of other avoid damaging the vehicle. vehicles can induce the Park Assist system orPark Assist interrupts the manoeuvres for e ● The ultrasound sensors on the bumper may ParkPilot to give erroneous warnings.parking or exiting a parking space in any of ic be damaged or shifted in the event of a colli- the following cases: ● In order to become familiar with the system Adv sion, for example, when entering or exiting a and its functions, SEAT recommends that you parking space. ●Button  is pressed. practice operating the Park Assist system in ● If you use high-pressure or vapour equip- an area where there is not too much traffic or●The speed exceeds approximately 7 km/h ment to clean the ultrasound sensors, do not in a car park. (4 mph). apply it directly unless very briefly and al- ●The driver takes hold of the steering wheel. ways from a distance of more than 10 cm. ation ●The parking manoeuvre does not end with- ● A registration plate or plate holder on the Description of the Park Assist system pr in apoximately 6 minutes following activa-Oper front with larger than the space for the regis- tion of the automatic steering. tration plate, or a registration plate that is curved or warped can cause: ●There is a fault in the system (the system is s – false detections, temporarily unavailable). ie – loss of sensor visibility, ●ASR is switched off. enc g – cancellation of the parking manoeuvre or ● ASR or ESC intervene with regulation. defective parking. ● Emer The driver door is opened. ● If one of the ultrasonic sensors is damaged, the area corresponding to that group of sen- To restart the manoeuvre it is necessary that sors (front or rear) is deactivated and cannot none of these things occur and that button be activated until the fault is corrected. How-  is pressed again. » ety ever, you can still use the sensors of the oth- Fig. 200 At the top of the centre console: but- Saf er bumper as per usual. If there is a fault in ton to switch on the Park Assist system. the system, consult a specialist workshop. SEAT recommends visiting a SEAT dealership The components of Park Assist system are for this. ltr the uasonic sensors located in the front 233

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders