owners manual Skoda Superb

all ratings: 0 average rating: 5

Jump-starting using the battery from another vehicle Jump-starting in vehicles with the S0AR0-S0OP system Fig. ĖĝĜ Fig. Ėĝĝ Jump-starting: A – flat battery, B Engine compartment: Earth – battery providing current First read and observe the introductory information and safety warn- First read and observe the introductory information and safety warn- ings on page ėėĝ. ings on page ėėĝ.  0he battery of another vehicle can be used to jump-start your vehicle if the en-On vehicles with the S0AR0-S0OP system, the jump-start cable must only be con-  gine will not start because the battery is flat. Jump-start cables are required fornected to the engine earthing point » Fig. Ėĝĝ. this purpose. 0he jump-start cables must be attached in the following sequence. Jump-starting vehicles with the vehicle battery in the boot ›Attach clamp Ė to the positive terminal of the discharged battery A » Fig. ĖĝĜ. ›Attach clamp ė to the positive terminal of the battery supplying power B . ›Attach clamp Ę to the negative terminal of the battery supplying power B . Fig. ĖĝĞ ›Attach the clamp ę to a solid metal component firmly connected to the engine Detail of the engine compart- block or to the engine block itself. ment: Jump-starting point Starting engine ›Start the engine on the vehicle providing the power and allow it to idle. ›Start the engine of the vehicle with the discharged battery. ›If the engine does not start, halt the attempt to start the engine after Ėĕ sec- onds and wait for Ęĕ seconds before repeating the process. ›Disconnect the cables in exactly the reverse order to the one described above. First read and observe the introductory information and safety warn- Both batteries must have a rated voltage of Ėė 2. 0he capacity (Ah) of the battery ings on page ėėĝ. supplying the power must not be significantly less than the capacity of the dis- charged battery in your vehicle. On vehicles with the vehicle battery in the boot, the positive terminal of the bat- Jump-start cables tery supplying the power can only be connected to the jump-starting point in the Only use jump-start cables which have an adequately large cross-section and in-engine compartment of the vehicle being started by means of a jump-start ca- sulated terminal clamps. Observe the manufacturer's instructions. ble » Fig. ĖĝĞ! Positive cable - colour coding in the majority of cases is red. Open the protective cap of the jump-starting point in the direction of the ar- › row » Fig. ĖĝĞ.   Negative cable - colour coding in the majority of cases is black. Emergency equipment and self-helpėėĞ

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders