owners manual Subaru Forester

all ratings: 0 average rating: 5

7-12 Starting and operating feature programming can be adjusted Pressing the brake pedal repeatedly willtery. using the following procedure.toggle the feature ON or OFF each time Batteries should not be exposed 1. Open the driver’s door (the driver’s7. To exit the remote transmitter andto excessive heat such as sun- door must remain opened throughout thefeature programming mode, turn the igni-shine, fire or the like. entire process). tion switch to the “LOCK” position, remove 2. Insert the key into the vehicle’s ignitionthe key from the ignition switch and testThe two 3-volt lithium batteries (model switch and turn to the “ON” position.operation of the remote transmitter(s) andCR-1220) supplied in your remote control 3. Locate the small black programminghorn confirmation feature.should last approximately 3 years, de- button behind the fuse box cover, on the pending on usage. When the batteries driver’s side left under the dashboard&Systemmaintenancebegin to weaken, you will notice a panel. ! Changing the remote control bat-decrease in range (distance from the 4. Pressandholdtheblackprogrammingteries vehicle that your remote control operates). button for 10 to 15 seconds. The horn will Follow the instructions below to change honk and the turn signal lights will flash the remote control batteries. three times to indicate that the system hasCAUTION entered programming mode. At this point. Donotletdust,oilorwatergeton youcanproceedtoeither step 5 or step 6.or in the remote engine start 5. To program a remote transmitter: transmitter when replacing the press and release the “” button on eachbattery. transmitter. The horn will honk and the. Be careful not to damage the turn signal lights will flash one time toprinted circuit board in the re- indicate a successful transmitter learnmote engine start transmitter each time the “” button is pressed. Youwhen replacing the battery. can program up to eight transmitters. 6. To toggle the Horn Confirmation chirps. Becarefulnottoallowchildrento ON/OFF: press and release the brake totouch the battery and any re- toggle the feature. The horn will chirp andmoved parts; children could the turn signal lights will flash one time toswallow them. indicate Confirmation Horn Chirps are. There is a danger of explosion if “OFF”. The horn will honk and the turnan incorrect replacement battery signal lights will flash 2 times to indicateis used. Replace only with the Confirmation Horn Chirps are“ON”.same or equivalent type of bat-

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders