owners manual Skoda Kodiaq

all ratings: 0 average rating: 5

Note 0he brightness of the indicator light  is dependent on the setting of the ve- hicle lighting. 3ith the low or high beam on the brightness of the light will be lower. Activation / deactivation Read and observe and on page ėėę first. 0he activation or deactivation of the system can be carried out in one of the following ways. Fig. ėĜě Driving situation / indicator light in the right outside mirror indi- ▶ In the instrument cluster display » page ęĞ, Menu itemAssist systems. cates the driving situation ▶  In the Infotainment in the menu →  → Driver assistance (Applies to the wizard for “Blind Spot” Monitoring). Read and observe and on page ėėę first. ▶  In the Infotainment in the menu →  → Parking and manoeuvring (Applies to Rear 0raffic Alerts). In the following situations, the indicator light in the outside mirror indicates a vehicle in the “blind spot”. After switching off and switching on the ignition, depending on the setting pri- ▶ 5ou vehicle B is being overtaken by vehicle A » Fig. ėĜĚ. or to switching off the ignition, the systems remains activated / deactivated. ▶ 5our vehicle C overtakes the vehicle D at a greater speed of max. Ėĕ km» Fig. ėĜě. If the speed during the overtaking is even higher, then there isNote no warning by the warning light. 3hen activating the wizard for “blind spot” monitoring, the  warning lights illuminate briefly in the two exterior mirrors. 0he warning display is always in the exterior mirror on the side of the vehicle where a vehicle is detected in the “blind spot”. Malfunctions 0he greater the speed difference between the two vehicles, the earlier the warning (by means of the warning light) regarding the vehicle that is overtak-Read and observe and on page ėėę first. ing you takes place. If the systems are not available for some unknown reason, an appropriate 0wo warning levels message appears in the display of the instrument cluster.  light up - a vehicle has been detected in the “blind spot”. Sensor covered / dirty  flash - a vehicle has been detected in the “blind spot” and the turn signal is If the sensor is dirty or covered, a message indicating that there is no sensor switched on. view appears. Clean or remove the obstructing object from the sensor environ- ment » Fig. ėĜĘ on page ėėę. An advanced warning for vehicles with Lane Assist  flash also if the steering wheel is turned in the direction of the vehicle in Systems unavailable the “blind spot” . 0herefore the Lane Assist » page ėĚę must be enabled and If the systems are currently unavailable, a message regarding the unavailability the boundary line between the vehicles detected. appears. Stop the vehicle, switch off the engine and then start it again. If the If in this case your vehicle indicates crossing the boundary line, with a short vi-systems are still not available, seek the assistance of a specialist garage. bration of the steering wheel. System fault In the case of a system fault, an error message appears. Seek help from a spe- cialist garage. ėėě Driving

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders