owners manual Seat Leon

all ratings: 0 average rating: 5

leon_EN.book Seite 226 Donnerstag, 15. April 2010 9:19 09 226 Checking and refilling levels Opening the coolant expansion tank The coolant additive G 12+ (dyed purple) may be mixed with G 12 (dyed red) – Switch off the engine and allow it to cool. and also with G 11. – To prevent scalding, cover the cap on the expansion tank with a WARNING thick cloth and carefully unscrew the cap ⇒. Any work carried out in the engine compartment or on the engine must be Checking coolant level carried out cautiously. – Look into the open coolant expansion tank and read off the • When working in the engine compartment, always observe the safety coolant level. warnings ⇒page218. • When the engine is warm or hot, the cooling system is pressurised! Do – If the level is below the “MIN” mark, top up with coolant.not unscrew the cap on the expansion tank when the engine is hot. This is a burn injury risk. Topping up coolant –Only usnewe coolant liquid. Caution – Do not fill above the “MAX” mark. • When mixed with other additives the colour of G 12 will change to brown. If this occurs you should have the coolant changed immediately. Failure to do Closing the coolant expansion tank so will result in engine damage! – Screw the cap on again tightly. • If a lot of liquid coolant has been lost, wait for the engine to cool down before putting in cold coolant. This avoids damaging the engine. Large coolant losses are an indication of leaks in the cooling system. See a special- The position of the coolant expansion reservoir is shown in the corresponding ised workshop immediately and have the cooling system checked. Other- engine compartment illustration ⇒ page 275. wise, there is a risk of engine damage. Make sure that the coolant meets the required specifications ⇒page 225. Do not use a different type of additive if coolant additive G 12+ is not avail- able. In this case use only water and bring the coolant concentration back up to the correct level as soon as possible by putting in the specified additive ⇒page225. Always top up with new coolant. Do not fill above the “MAX” mark. Otherwise the excess coolant will be forced out of the cooling system when the engine is hot.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders