Mercedes Benz SLR McLaren R199 owners manual page 226

text version of content this owner's manual page from owners manual to the vehicle Mercedes SLR, year of production 2003 - 2009:

Controls in detail Useful features iUpon completion of programming the inte-Operation of integrated remote controlProgramming tips grated remote control, make sure you retain the Switch on the ignition ( page 40).If you are having difficulty programming hand-held remote control that came with the ga- the integrated remote control, here are rage door opener, gate operator or other device. Select and press the appropriate inte-some helpful tips: You may need it for use in other vehicles, for fu-grated signal transmitter button (2, ture programming of an integrated remote con-3 or4) to activate the remote Check the frequency of the hand-held trol, or simply for continued use as a hand-held controlled device.remote control 5 (typically located on remote control to operate the respective device the reverse side of the remote). The in- in other situations. The integrated remote control trans-tegrated remote control is compatible mitter continues to send the signal as with radio-frequency devices operating Reprogramming a single signal long as the button is pressed – up to between 280-390 MHz. transmitter button 20seconds. To program a device using a signal trans- Put a new battery in hand-held remote mitter button previously trained, follow Erasing the integrated remote control control 5. This will increase the likeli- these steps: memory hood of the hand-held remote control Switch on the ignition ( page 40).sending a faster and more accurate sig- Switch on the ignition ( page 40). nal to the integrated remote control. Press and hold the desired signal Simultaneously press and hold outer While performing step 3, hold transmitter button (2, 3 or 4). signal transmitter buttons 2 and 4, hand-held remote control 5 at differ- Donot release the button. for approximately 20 seconds, until ent lengths and angles from the signal indicator lamp1 flashes rapidly. Do transmitter button (2, 3 or 4) you Indicator lamp1 will begin to flash af-not hold for longer than 30 seconds. ter 20 seconds. Without releasing the are programming. Attempt varying signal transmitter button, proceed with The codes of all three channels are angles at the distance of 2 to 5 in programming starting with step 3.erased. (5 to 12 cm) away or the same angle at iIf you sell your vehicle, erase the codes of all varying distances. three channels. 225

owners manual Mercedes SLR

owners manual Mercedes SLR - year of production: 2003, 2004, 2005, 2006, 2007, 2008, 2009 - Mercedes Benz SLR McLaren R199 owners manual EN