Mercedes Benz SLR McLaren R199 owners manual page 224

text version of content this owner's manual page from owners manual to the vehicle Mercedes SLR, year of production 2003 - 2009:

Controls in detail Useful features Step 3: Step 5: Rolling code programming Hold the end of hand-held remote After indicator lamp 1 changes from a To train a garage door opener (or other control 5 of the device you wish to slow to a rapidly flashing light, release rolling code devices) with the rolling code train approximately 2 to 5 in the hand-held remote control button feature, follow these instructions after (5 to12 cm) away from the signal trans-and the signal transmitter button.completing the “Programming” portion mitter button (2, 3 or 4) to be Step 6: (steps 1 through 6) of this text. (A second programmed, while keeping indicator person may make the following training lamp1 in view. Press and hold the just-trained signal procedures quicker and easier.) Step 4: transmitter button (2, 3 or 4) and Step 8: observe indicator lamp 1. Using both hands, simultaneously If the indicator lamp 1 stays on Locate “training” button on the garage press hand-held remote control constantly, programming is complete door opener motor head unit. button 6 and the desired signal trans-and your device should activate when Exact location and color of the button mitter button (2, 3 or 4). Do not the respective signal transmitter may vary by garage door opener brand. release the buttons until step 5 is button (2, 3 or 4) is pressed and Depending on manufacturer, the completed. released. “training” button may also be referred Indicator lamp 1 will flash, first slowly iIf indicator lamp 1 flashes rapidly for about to as “learn”or “smart” button. If there and then rapidly. 2seconds and then turns to a constant light, is difficulty locating the transmitting iIndicator lamp 1 flashes immediately the continue with programming steps 8 through 12 button, refer to the garage door opener first time the signal transmitter button is pro-as your garage door opener may be equipped Operator’s Manual. grammed. If this button has already been with the “rolling code” feature. programmed, the indicator lamp will only start Step 7: flashing after 20 seconds. To program the remaining two signal transmitter buttons, repeat the steps above starting with step 3. 223

owners manual Mercedes SLR

owners manual Mercedes SLR - year of production: 2003, 2004, 2005, 2006, 2007, 2008, 2009 - Mercedes Benz SLR McLaren R199 owners manual EN