Nissan Juke owners manual page 225

text version of content this owner's manual page from owners manual to the vehicle Nissan Juke, year of production 2010:

Black plate (225,1) 3minutes before shutting it off. Starting andDepress the brake pedal (CVT models) orCAUTION stopping the engine over a short period ofthe clutch pedal (MT models) and push the time may make the vehicle more difficult toignition switch to start the engine. start. Do not operate the starter for more To start the engine immediately, push andthan 15 seconds at a time. If the engine 5.To stop the engine, move the selector leverrelease the ignition switch while depressingdoes not start, push the ignition switch to the P (Park) position (CVTmodel) or movethe brake pedal with the ignition switch into OFF and wait 10 seconds before the shift lever to the N (Neutral) position (MTany position.cranking again, otherwise the starter model), and turn the ignition switch to the.Ifthe engine is very hard to start incould be damaged. OFF position. extremely cold weather or when restart- MODELSWITHINTELLIGENT KEY ing, depress the accelerator pedal a little4.Warm-up SYSTEM (approximately 1/3 to the floor) andAllow the engine to idle for at least 30 while holding, crank the engine. Releaseseconds after starting. Do not race the 1.Apply the parking brake. the accelerator pedal when the engineengine while warming it up. Drive at 2.Move the selector lever to the P (Park) or Nstarts. moderate speed for a short distance first, (Neutral) position. (P is recommended.).Ifthe engine is very hard to startespecially in cold weather. In cold weather, Thestarter is designed not to operate unlessbecause it is flooded, depress thekeeptheenginerunningforaminimumof2- the selector lever is in either of the aboveaccelerator pedal all the way to the floor3minutes before shutting it off. Starting and positions. and hold it. Push the ignition switch tostopping the engine over a short period of the ON position to start cranking thetime may make the vehicle more difficult to Manual Transmission (MT) models: engine. After 5 or 6 seconds, stopstart. Move the shift lever to the N (Neutral)cranking by pushing the ignition switchWhenracing the engine up to 4,000 rpm or position. Depress the clutch pedal fully toto OFF. After cranking the engine,more under no load condition, the engine the floor. release the accelerator pedal. Crankwill enter the fuel cut mode. the engine with your foot off the Thestarter is designed not to operate unlessaccelerator pedal by depressing the5.To stop the engine, move the selector lever the clutch pedal is fully depressed.brake pedal and pushing the push-to the P (Park) position (CVT models) or button ignition switch to start the engine.move the shift lever to the N (Neutral) The Intelligent Key must be carriedIfthe engine starts, but fails to run,position (MT models), and push the ignition when operating the ignition switch.repeat the above procedure.switch to the OFF position. 3.Push the ignition switch to the ON position. Starting and driving5-15 Model "F15-D" EDITED: 2011/ 2/ 21

owners manual Nissan Juke

owners manual Nissan Juke - year of production: 2010 - Nissan Juke owners manual EN