owners manual Skoda Superb

all ratings: 0 average rating: 5

3ARNING Preliminary work ■ If you are in flowing traffic, switch on the hazard warning light system and First read and observe the introductory information and safety warn- set up the warning triangle at the prescribed distance! 0he national legal re- ings on page ėėė.  quirements must be observed. ■ Park the vehicle as far away as possible from the flow of traffic. Park on as Always change a wheel on a level surface as far as possible. flat and firm a surface as possible. 0he following steps must be carried out before actually changing the wheel: ■ 0he following instructions must be followed if the vehicle is subsequently fitted with tyres or rims that differ from the factory-fitted ones » page ėĖě, ›Let all of the occupants get out. 3hile changing a tyre, the occupants of the New tyres. vehicle should not stand on the road (instead they should remain behind a crash barrier). ›Switch off the engine. 3ARNING ›Move the gearshift lever into Neutral or move the selector lever for the auto- matic gearbox into position P. Observe the following instructions for lifting the vehicle. ■ ›Firmly apply the handbrake. If the wheel has to be changed on a slope, first of all block the opposite ›If a trailer is connected, uncouple it. wheel with a stone or similar object to prevent the vehicle from unexpectedly ›Remove the vehicle tool kit » page ėėė and the spare wheel » page ėĖĝ from rolling away.  ■ the boot. Secure the base plate of the lifting jack with suitable means to prevent pos- sible moving. A soft and slippery ground under the base plate may move the lifting jack, causing the vehicle to fall down. It is therefore always necessary to Changing a wheel place the lifting jack on a solid surface or use a wide and stable base. 1se a non-slip base (e.g. a rubber foot mat) if the surface is smooth, such as cobbled First read and observe the introductory information and safety warn- stones, tiled floor, etc. ings on page ėėė. ■  Only attach the lifting jack to the attachment points provided for this pur- pose. ›Remove the full wheel trim » page ėĖĞ or caps » page ėĖĞ. ■ Always raise the vehicle with the doors closed. ›First of all slacken the anti-theft wheel bolt and then the other wheel ■ Never position any body parts, such as arms or legs under the vehicle, while bolts » page ėėę. the vehicle is raised with a lifting jack. ›Jack up the vehicle until the wheel that needs changing is clear of the ■ Never start the engine when the vehicle is raised – risk of injury. ground » page ėėĚ. ›1nscrew the wheel bolts and place them on a clean surface (cloth, paper, etc.). CA10ION ›Remove the wheel. ›Attach the spare wheel and slightly screw on the wheel bolts. ■ 0he prescribed tightening torque of the wheel bolts for steel and light alloy ›Lower the vehicle. wheels is Ėėĕ Nm. ›Alternately tighten wheel bolts opposite (diagonally) with the wheel wrench. ■ If the wheel bolts are fastened too tightly, this can cause damage to the anti- 0ighten the anti-theft wheel bolt last » page ėėę. theft wheel bolt and the adapter. Replace the wheel trim or the caps.  › Note ■ 0he anti-theft wheel bolt set and adapter can be purchased from a ŠKODA Part- ner. ■  0he national legal requirements must be observed when changing a wheel. Emergency equipment and self-helpėėĘ

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders