Mitsubishi Galant IX 9 owners manual page 216

text version of content this owner's manual page from owners manual to the vehicle Mitsubishi Galant, year of production 2003 - 2012:

BK0121200US.book 127 ページ㧞㧜㧝㧜年４月㧝４日　水曜日　午前㧝㧝時㧞４分 Features and controls If you continue to have programming difficulties, please con-General information tact an authorized Mitsubishi Motors dealer or a repair facility Your HomeLink® system operates on a radio frequency sub- of your choice. ject to Federal Communications Commission (FCC) Rules Clearing the programmed information (For vehicles sold in U.S.A.) and Industry Canada Rules (For To clear all programming, press and hold the two outside but- vehicles sold in Canada). This device complies with Part 15 of the FCC Rules and RSS- 210 of the Industry Canada Rules. tons and release when the indicator light begins to flash Operation is subject to the following two conditions. (approximately 20 seconds) individual buttons cannot be cleared. ●This device may not cause interference. ●This device must accept any interference received, includ- Reprogramming a single HomeLink® button ing interference that may cause undesired operation. To reprogram a HomeLink® button, complete the following. 1. Press and hold the desired HomeLink® button. Do not!CAUTION release the button until step 4 has been completed.●Changes or modifications not expressly approved by3 2. When the indicator light begins to flash slowly (after 20the manufacturer for compliance could void the seconds), position the hand-held transmitter 2 to 5 inchesuser’s authority to operate the equipment. (50 to 127 mm) away from HomeLink® surface. 3. Press and hold the hand-held transmitter button. 4. HomeLink® indicator light will flash, first slowly and then rapidly. When the indicator light begins to flash rap- idly, release both buttons. The new device can be activated by pushing HomeLink® but- ton that was just programmed. This procedure will not affect any other programmed HomeLink® buttons. If your vehicle is stolen If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLink®. Consult the Owner’s Manual of each device or call the manufacturer or dealer of those devices for additional information. When your vehicle is recovered, you will need to reprogram HomeLink® with your new transmitter information. 3-127

owners manual Mitsubishi Galant

owners manual Mitsubishi Galant - year of production: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012 - Mitsubishi Galant IX 9 owners manual EN